Robust mode recognition in Hybrid Dynamical Systems with nonlinear modes

Switching detection and active mode recognition in Hybrid Dynamical Systems (HDS) with nonlinear continuous dynamics are considered in this paper. The nonlinear modes are represented by Takagi-Sugeno models. Two methods based on projection techniques are proposed to generate a bank of residuals which are mode indicators: the first one is the well-known parity space method which uses the TS model parameters, the second one is a data-based projection method that does not need the parameter values of the TS model. Robustness of the two methods against parameter uncertainties is discussed. An illustrative example is provided to show the effectiveness of the proposed methods.

[1]  R. Patton,et al.  A robust parity space approach to fault diagnosis based on optimal eigenstructure assignment , 1991 .

[2]  Bin Jiang,et al.  Fault Tolerant Control Design for Hybrid Systems , 2010 .

[3]  J. Gertler.  Fault detection and isolation using parity relations , 1997 .

[4]  A. Morse,et al.  Stability of switched systems with average dwell-time , 1999, Proceedings of the 38th IEEE Conference on Decision and Control (Cat. No.99CH36304).

[5]  Michio Sugeno,et al.  Fuzzy identification of systems and its applications to modeling and control , 1985, IEEE Transactions on Systems, Man, and Cybernetics.

[6]  Didier Maquin,et al.  Proportional-Integral observer design for nonlinear uncertain systems modelled by a multiple model approach , 2008, 2008 47th IEEE Conference on Decision and Control.

[7]  Jean-Philippe Cassar,et al.  Fault detection and Isolation from an identified MIMO Takagi-Sugeno model of a bioreacto , 2009 .

[8]  Johannes Schumacher,et al.  An Introduction to Hybrid Dynamical Systems, Springer Lecture Notes in Control and Information Sciences 251 , 1999 .

[9]  Jean-Philippe Cassar,et al.  Identification of MIMO Takagi-Sugeno model of a bioreactor , 2007, 2007 IEEE International Fuzzy Systems Conference.

[10]  José Ragot,et al.  Switching systems: active mode recognition, identification of the switching law , 2007 .

[11]  José Ragot,et al.  Identification of an output error Takagi-Sugeno model , 2000, Smc 2000 conference proceedings. 2000 ieee international conference on systems, man and cybernetics. 'cybernetics evolving to systems, humans, organizations, and their complex interactions' (cat. no.0.

[12]  Rolf Isermann,et al.  Model-based fault-detection and diagnosis - status and applications , 2004, Annu. Rev. Control..

[13]  W. Marsden.  I and J , 2012 .

[14]  D. Fussel,et al.  Detection and isolation of sensor faults on nonlinear processes based on local linear models , 1997, Proceedings of the 1997 American Control Conference (Cat. No.97CH36041).

[15]  Torsten Jeinsch,et al.  A characterization of parity space and its application to robust fault detection , 1999, IEEE Trans. Autom. Control..

[16]  Marcel Staroswiecki,et al.  Generation of Analytical Redundancy Relations for FDI purposes , 1997 .

[17]  Didier Theilliol,et al.  Some extensions to the parity space method for FDI using alternated projection subspaces , 1995, Proceedings of 1995 34th IEEE Conference on Decision and Control.

[18]  Jean-Philippe Cassar,et al.  Optimal design of FDI systems via parity space and observer based approaches , 1991, Proceedings IECON '91: 1991 International Conference on Industrial Electronics, Control and Instrumentation.

[19]  A. Rakar,et al.  Identification of nonlinear processes and model based fault isolation using local linear models , 1997, Proceedings of the 1997 American Control Conference (Cat. No.97CH36041).

[20]  V. Cocquempot,et al.  Fault detection and isolation for hybrid systems using structured parity residuals , 2004, 2004 5th Asian Control Conference (IEEE Cat. No.04EX904).

[21]  Mehdi Bayoudh,et al.  Hybrid Systems Diagnosability by Abstracting Faulty Continuous Dynamics , 2006 .

[22]  G. G. Stokes.  "J." , 1890, The New Yale Book of Quotations.