Multi-Disciplinary Tolerance Optimization for Internal Combustion Engines Using Gaussian Process and Sequential MDO Method

[1]  M. F. Spotts.  Allocation of Tolerances to Minimize Cost of Assembly , 1973 .

[2]  Thomas J. Santner,et al.  The Design and Analysis of Computer Experiments , 2003, Springer Series in Statistics.

[3]  A. O'Hagan,et al.  Bayesian calibration of computer models , 2001 .

[4]  Paul D. Arendt,et al.  Quantification of model uncertainty: Calibration, model discrepancy, and identifiability , 2012 .

[5]  Xie Youbai.  Analysis and Calculation of Friction of Piston-Assembly Based on IMEP Method , 2007 .

[6]  J. N. Siddall,et al.  The Optimization Problem With Optimal Tolerance Assignment and Full Acceptance , 1981 .

[7]  Zhang Ying-jia.  Effect of Compression Ratio on Combustion and Emission Characteristics of a Direct-Injection Natural Gas Engine , 2010 .

[8]  F. H. Speckhart,et al.  Calculation of Tolerance Based on a Minimum Cost Approach , 1972 .

[9]  A. O'Hagan,et al.  Bayesian emulation of complex multi-output and dynamic computer models , 2010 .

[10]  Jianhua Zhou,et al.  A New Sequential Multi-Disciplinary Optimization Method for Bi-Level Decomposed Systems , 2015, DAC 2015.

[11]  G. Box,et al.  On the Experimental Attainment of Optimum Conditions , 1951 .

[12]  L. F. Hauglund,et al.  Least Cost Tolerance Allocation for Mechanical Assemblies with Automated Process Selection , 1990 .

[13]  Li Zi-fei.  Discussion on Spark-Ignited Variable Compression Ratio Engine , 2011 .

[14]  John B. Heywood,et al.  Effects of Combustion Phasing, Relative Air-fuel Ratio, Compression Ratio, and Load on SI Engine Efficiency , 2006 .

[15]  Ozgen Akalin,et al.  Piston Ring-Cylinder Bore Friction Modeling in Mixed Lubrication Regime: Part II—Correlation With Bench Test Data , 2001 .