Optimization of design and fabrication for micromachined true time delay (TTD) phase shifters

Distributed techniques have been widely employed as a solution to obtain wide band circuits at microwave and millimeter wave band. This paper presents five different designs for true-time delay (TTD) phase shifters that are based on characteristic impedance of 75, 65 and 50 � coplanar waveguide (CPW) distributed microelectromechanical systems (MEMS) transmission line (DMTL), which are loaded with different designs and number of shunt capacitive switches. The TTD phase shifters are fabricated on a 675m high resistivity silicon (Si) wafer using surface micromachining process. The design operates up to Ku band with a measured return loss below −15 dB and an average loss of 2.3 dB/phase shift of 250 ◦ at 20 GHz. The TTD phase shifters have wide applications for high-performance of microwave and millimeter-wave

[1]  Elliott R. Brown,et al.  RF-MEMS switches for reconfigurable integrated circuits , 1998 .

[2]  M. Rodwell,et al.  Active and nonlinear wave propagation devices in ultrafast electronics and optoelectronics , 1994, Proc. IEEE.

[3]  G.E. Ponchak,et al.  Microelectromechanical switches for phased array antennas , 2000, IEEE Antennas and Propagation Society International Symposium. Transmitting Waves of Progress to the Next Millennium. 2000 Digest. Held in conjunction with: USNC/URSI National Radio Science Meeting (C.

[4]  P. Pinsky,et al.  Nonlinear dynamic modeling of micromachined microwave switches , 1997, 1997 IEEE MTT-S International Microwave Symposium Digest.

[5]  D. Pozar.  Microwave Engineering , 1990 .

[6]  G.M. Rebeiz,et al.  2 and 4-bit DC-18 GHz microstrip MEMS distributed phase shifters , 2001, 2001 IEEE MTT-S International Microwave Sympsoium Digest (Cat. No.01CH37157).

[7]  C. Goldsmith,et al.  Micromechanical membrane switches for microwave applications , 1995, Proceedings of 1995 IEEE MTT-S International Microwave Symposium.

[8]  Gabriel M. Rebeiz,et al.  Distributed MEMS true-time delay phase shifters and wide-band switches , 1998 .

[9]  S. Senturia,et al.  Self-consistent simulation and modelling of electrostatically deformed diaphragms , 1994, Proceedings IEEE Micro Electro Mechanical Systems An Investigation of Micro Structures, Sensors, Actuators, Machines and Robotic Systems.

[10]  S. Eshelman,et al.  Characteristics of micromachined switches at microwave frequencies , 1996, 1996 IEEE MTT-S International Microwave Symposium Digest.

[11]  Jung-Chih Chiao.  MEMS RF devices for antenna applications , 2000, 2000 Asia-Pacific Microwave Conference. Proceedings (Cat. No.00TH8522).

[12]  G.M. Rebeiz,et al.  2-bit MEMS distributed X-band phase shifters , 2000, IEEE Microwave and Guided Wave Letters.

[13]  K. Sarabandi,et al.  Electromechanical considerations in developing low-voltage RF MEMS switches , 2003 .

[14]  Reinmut K. Hoffmann,et al.  Handbook of microwave integrated circuits , 1987 .

[15]  Ai Qun Liu,et al.  Mechanical characterization of micromachined capacitive switches: design consideration and experimental verification , 2003 .