Austenite grain refinement during load-biased thermal cycling of a Ni 49.9 Ti 50.1 shape memory alloy

Abstract A near-equiatomic NiTi shape memory alloy was subjected to a variety of thermomechanical treatments including pure thermal cycling and load-biased thermal cycling to investigate microstructural evolution of the material under actuating conditions. In situ and post mortem scanning transmission electron microscopy (STEM) was used to study the effects of stress on the development of defect substructures during cycling through the martensitic transformation. High temperature observations of the austenite phase show rapid accumulation of dislocations and moderate deformation twinning upon thermomechanical cycling. Additionally, TEM-based orientation mapping suggests the emergence of fine crystallites from the original coarse austenite grain structure. A possible mechanism is proposed for the observed grain refinement based on the crystallographic theory of martensite transformation.

[1]  E. Okunishi,et al.  Self-accommodation of B19′ martensite in Ti–Ni shape memory alloys – Part II. Characteristic interface structures between habit plane variants , 2012 .

[2]  G. Eggeler,et al.  Pseudoelastic cycling of ultra-fine-grained NiTi shape-memory wires , 2005 .

[3]  Gunther Eggeler,et al.  Elementary Transformation and Deformation Processes and the Cyclic Stability of NiTi and NiTiCu Shape Memory Spring Actuators , 2009 .

[4]  Othmane Benafan,et al.  Thermomechanical cycling of a NiTi shape memory alloy-macroscopic response and microstructural evolution , 2014 .

[5]  Yong Qing Fu,et al.  TiNi-based thin films in MEMS applications: a review , 2004 .

[6]  Shuichi Miyazaki,et al.  Effect of thermal cycling on the transformation temperatures of TiNi alloys , 1986 .

[7]  Gunther Eggeler,et al.  On the multiplication of dislocations during martensitic transformations in NiTi shape memory alloys , 2010 .

[8]  K. Bhattacharya.  Microstructure of martensite : why it forms and how it gives rise to the shape-memory effect , 2003 .

[9]  Xiangyang Huang,et al.  Crystal structures and shape-memory behaviour of NiTi , 2003, Nature materials.

[10]  C. M. Wayman,et al.  Introduction to the crystallography of martensitic transformations , 1964 .

[11]  Blythe G. Clark,et al.  On the plasticity of small-scale nickel–titanium shape memory alloys , 2010 .

[12]  L. Brinson,et al.  Micromechanical quantification of elastic, twinning, and slip strain partitioning exhibited by polycrystalline, monoclinic nickel–titanium during large uniaxial deformations measured via in-situ neutron diffraction , 2013 .

[13]  D. Dye,et al.  Influence of applied stress on the transformation behaviour and martensite evolution of a Ti–Ni–Cu shape memory alloy , 2013 .

[14]  H. Kawano,et al.  Self-accommodation of B19′ martensite in Ti–Ni shape memory alloys – Part I. Morphological and crystallographic studies of the variant selection rule , 2012 .

[15]  Robert Sinclair,et al.  Effects of thermal cycling on microstructure and properties in Nitinol , 2012 .

[16]  Huseyin Sehitoglu,et al.  Stress dependence of the hysteresis in single crystal NiTi alloys , 2004 .

[17]  H. Hosoda,et al.  Self-accommodation of B19′ martensite in Ti–Ni shape memory alloys. Part III. Analysis of habit plane variant clusters by the geometrically nonlinear theory , 2012 .

[18]  M. Graef,et al.  Characterization and modeling of defects generated in pseudoelastically deformed NiTi microcrystals , 2014 .

[19]  D. Dye,et al.  In-Situ Synchrotron Characterization of Transformation Sequences in TiNi-Based Shape Memory Alloys during Thermal Cycling , 2010 .

[20]  J. Mackenzie,et al.  The crystallography of martensite transformations II , 1954 .

[21]  T. Pirling,et al.  In‐situ diffraction investigation of superelastic NiTi shape memory alloys under mechanical stress with neutrons and with synchrotron radiation , 2004 .

[22]  S. Padula,et al.  Temperature dependent deformation of the B2 austenite phase of a NiTi shape memory alloy , 2013 .

[23]  L. Brinson,et al.  Neutron diffraction studies and multivariant simulations of shape memory alloys: Concurrent verification of texture development and mechanical response predictions , 2011 .

[24]  Bradley A. Lerch,et al.  Temperature-dependent behavior of a polycrystalline NiTi shape memory alloy around the transformation regime , 2013 .

[25]  M. Elahinia,et al.  Manufacturing and processing of NiTi implants: A review , 2012 .

[26]  X. Ren,et al.  Physical metallurgy of Ti–Ni-based shape memory alloys , 2005 .

[27]  P. Anderson,et al.  Transformation-induced plasticity during pseudoelastic deformation in Ni–Ti microcrystals , 2009 .

[28]  Othmane Benafan,et al.  An in situ neutron diffraction study of shape setting shape memory NiTi , 2013 .

[29]  Constantinos Mavroidis,et al.  Development of Advanced Actuators Using Shape Memory Alloys and Electrorheological Fluids , 2002, Research in Nondestructive Evaluation.

[30]  G. Eggeler,et al.  Neutron diffraction phase analysis during thermal cycling of a Ni-rich NiTi shape memory alloy using the Rietveld method , 2002 .

[31]  B. Franco,et al.  Influence of crystallographic compatibility on residual strain of TiNi based shape memory alloys during thermo-mechanical cycling , 2013 .

[32]  G. Olson,et al.  A Perspective on Martensitic Nucleation , 1981 .

[33]  D. Dye,et al.  Martensite evolution in a NiTi shape memory alloy when thermal cycling under an applied load , 2011 .

[34]  R. Margevicius,et al.  Study of the brittle-to-ductile transition in NiAl by texture analysis , 1995 .

[35]  Mark R. Daymond,et al.  In situ neutron diffraction studies of martensitic transformations in NiTi polycrystals under tension and compression stress , 2004 .