论文信息 - 3-dimensional numerical modelling of rolling of superconducting Ag/BSCCO tape

3-dimensional numerical modelling of rolling of superconducting Ag/BSCCO tape

Numerical simulation of the deformation process during flat rolling of multifilament HTS tapes has been investigated using a commercial FEM program, ELFEN. The numerical models were built up in 2D and 3D using a Drucker-Prager/Cap model for the powder. Three different roll diameters (o24 mm, o85 mm and o126 mm) have been investigated. It is found that it is possible to perform numerical simulation with 3D models of flat rolling of multifilament wire. Two 3D models have been used; 3D pressing with rolls and 3D rolling. 3D pressing with rolls have the advance that the simulation time is lower than in the 3D rolling. The 3D models have the advantage compared to 2D pressing that they can predict the 3 dimensional flow in the flat rolling, which has been showed to be very imported for the super conduction properties.

N. Bay | J. Bech | M. Eriksen | B. Seifi

[1] N. Bay,et al. Influence of strains in flat rolling on Jc of superconducting AgBSCCO-2223 tapes with thin, homogeneous filaments , 1999 .

[2] Björn Carlsson,et al. The contact pressure distribution in flat rolling of wire , 1998 .

[3] Eduardo N. Dvorkin,et al. 2D finite element parametric studies of the flat-rolling process , 1997 .

[4] D. Larbalestier,et al. Direct evidence for residual, preferentially-oriented cracks in rolled and pressed Ag-clad BSCCO-2223 tapes and their effect on the critical current density , 1996 .

[5] N. Bay,et al. Influence of process parameters in drawing of superconducting wire , 1999, IEEE Transactions on Applied Superconductivity.

[6] Lars-Erik Lindgren,et al. Explicit versus implicit finite element formulation in simulation of rolling , 1990 .

[7] P. Skov-Hansen,et al. Stresses and strains in multi-filament HTS tapes , 1999, IEEE Transactions on Applied Superconductivity.

[8] H. Zipse,et al. Finite-element simulation of the die pressing and sintering of a ceramic component , 1997 .

[9] S. Ahzi,et al. The bulk processing of 2223 BSCCO powders II. Tape rolling , 1996 .

[10] N. Bay,et al. Mechanical characterisation of superconducting BSCCO powder and numerical modelling of the OPIT process , 2000 .

[11] S. Tangrila,et al. Finite element modeling of the powder-in- tube process for manufacture of BSCCO-2212 superconducting wires , 1995 .