Performances of flax shive-based lightweight composites with rapid hardening

[1]  Laurent Arnaud,et al.  Acoustical properties of materials made of vegetable particles with several scales of porosity , 2011 .

[2]  Filiz Karaosmanoglu,et al.  Effect of expanded perlite on the mechanical properties and thermal conductivity of lightweight conc , 2011 .

[3]  E. Gourlay,et al.  Experimental study of parameters influencing mechanical properties of hemp concretes , 2012 .

[4]  L. H. Dall’Antonia,et al.  Properties of baked foams based on cassava starch, sugarcane bagasse fibers and montmorillonite , 2012 .

[5]  Xing Jin,et al.  Thermal performance evaluation of the wall using heat flux time lag and decrement factor , 2012 .

[6]  Martin D. Liu,et al.  Strength and compressibility of lightweight cemented clays , 2012 .

[7]  Bing Chen,et al.  A novel lightweight concrete-fabrication and its thermal and mechanical properties , 2013 .

[8]  Robert Černý,et al.  Computer aided design of interior thermal insulation system suitable for autoclaved aerated concrete structures , 2013 .

[9]  Robert Černý,et al.  Hygric, thermal and durability properties of autoclaved aerated concrete , 2013 .

[10]  R. Dheilly,et al.  Optimization of flax shive-cementitious composites: Impact of different aggregate treatments using linseed oil , 2014 .

[11]  Maria G. Alpuche,et al.  Comparative Analysis of the Thermal Behavior between Cellular Concrete Blocks and Stabilized Earth Blocks as Wall Materials , 2014 .

[12]  Derek B. Apel,et al.  Thermal properties of lightweight dry-mix shotcrete containing expanded perlite aggregate , 2014 .

[13]  Jong-Shin Huang,et al.  Inorganic polymeric foam as a sound absorbing and insulating material , 2014 .

[14]  Peter Walker,et al.  Comparing the Environmental Impact of Stabilisers for Unfired Earth Construction , 2014 .

[15]  Jian fei Chen,et al.  Mechanical Properties of Structures 3D-Printed With Cementitious Powders , 2015, 3D Concrete Printing Technology.

[16]  O. Douzane,et al.  Characterization of flax lime and hemp lime concretes: Hygric properties and moisture buffer capacity , 2015 .

[17]  Simon Ford,et al.  Additive manufacturing and sustainability: an exploratory study of the advantages and challenges , 2016 .

[18]  Vincent Dubois,et al.  Fresh and hardened state properties of hemp concrete made up of a large proportion of quarry fines for the production of blocks , 2016 .

[19]  D. Hoxha,et al.  Impact of accelerated climatic aging on the behavior of gypsum plaster-straw material for building thermal insulation , 2016 .

[20]  Christophe Lanos,et al.  Thermal and mechanical properties of gypsum–cement foam concrete: effects of surfactant , 2016 .

[21]  Zeyu Lu,et al.  Green lightweight cementitious composite incorporating aerogels and fly ash cenospheres – Mechanical and thermal insulating properties , 2016 .

[22]  Georges Aouad,et al.  Use of calcium sulfoaluminate cements for setting control of 3D-printing mortars , 2017 .

[23]  Ming Jen Tan,et al.  Anisotropic mechanical performance of 3D printed fiber reinforced sustainable construction material , 2017 .