This paper presents the results of scuffing tests performed with carburized AISI 9310 steel disks and a MIL-L-7808G oil, at a variety of sliding and sum velocities, and with disks ground both axially and circumferentially but with the same composite surface roughness. On the basis of these results, a methodology for correlating and predicting the thermal and scuffing behavior of sliding-rolling disks is suggested. It is demonstrated that the difference between the oil-film temperature at the conjunction inlet and the oil jet temperature, as well as the difference between the disk surface temperature and the oil jet temperature, are basically related to the frictional power loss at the sliding-rolling contact. The scuffing failure results are examined and compared by three different criteria: the critical temperature, the critical frictional power, and the critical frictional power intensity. It is shown that under certain operating conditions the critical temperature and critical frictional power intensit...
[1]
K. Johnson,et al.
Shear behaviour of elastohydrodynamic oil films at high rolling contact pressures
,
1967
.
[2]
R. M. Matveevsky.
The Critical Temperature of Oil With Point and Line Contact Machines
,
1965
.
[3]
H. J. Carper,et al.
Effect of some material and operating variables on scuffing
,
1973
.
[4]
M. J. Furey,et al.
Metallic Contact and Friction between Sliding Surfaces
,
1961
.
[5]
H. J. Carper,et al.
Effect of surface roughness and surface texture on scuffing
,
1973
.
[6]
B. W. Kelley,et al.
Temperature—The Key to Lubricant Capacity
,
1965
.
[7]
B. W. Kelley,et al.
Instantaneous Coefficients of Gear Tooth Friction
,
1961
.
[8]
B. W. Kelley.
A New Look at the Scoring Phenomena of Gears
,
1953
.
[9]
H. Blok.
The postulate about the constancy of scoring temperature
,
1970
.
[10]
Lubrication of concentrated contacts - The practical problem
,
1970
.