Separation of particles from syngas at high-temperatures with an electrostatic precipitator

Abstract The synthesis gas stemming from biomass gasification contains particles (ashes, soot, etc.), which, if not removed, can induce severe operational damage. The problem is more serious if syngas must be used for chemical synthesis as in the Fischer-Tropsch catalyst reaction or the water–gas shift. The particles contained in syngas can reduce or inhibit the catalyst effect. Moreover, for energy reasons, it is also necessary to develop a filtration process at as high a temperature as possible. To address this issue, a study to show the possibility of removing the particles from syngas with an electrostatic precipitator at high temperature (500–1000 °C) and pressure (0.1–1 MPa) was conducted. Syngas filtration tests conducted directly downstream of a gasifier demonstrated the feasibility of implementing an electrostatic precipitator to clean syngas at temperatures above 500 °C.

[1]  Heejoon Kim,et al.  The reduction and control technology of tar during biomass gasification/pyrolysis: An overview , 2008 .

[2]  Hartmut Spliethoff,et al.  Biomass and fossil fuel conversion by pressurised fluidised bed gasification using hot gas ceramic filters as gas cleaning , 2003 .

[3]  Wennan Zhang,et al.  Automotive fuels from biomass via gasification , 2010 .

[4]  Rolando Zanzi,et al.  Rapid high-temperature pyrolysis of biomass in a free-fall reactor , 1996 .

[5]  Steffen Heidenreich,et al.  Gas cleaning, gas conditioning and tar abatement by means of a catalytic filter candle in a biomass fluidized-bed gasifier. , 2010, Bioresource technology.

[6]  P. Moulin,et al.  Separation of particles from hot gases using metallic foams , 2009 .

[7]  Claus Hindsgaul,et al.  Physical and chemical characterization of particles in producer gas from wood chips , 2000 .

[8]  T. Nussbaumer,et al.  Gas cleaning for IC engine applications from fixed bed biomass gasification , 1999 .

[9]  Kj Krzysztof Ptasinski,et al.  Streamer corona plasma for fuel gas cleaning : comparison of energization techniques , 2005 .

[10]  Kazimierz Adamiak,et al.  Numerical modeling of negative-corona discharge in oxygen under different pressures , 2007 .

[11]  Donald E. Rugg,et al.  High-Temperature High-Pressure Electrostatic Precipitator Electrical Characterization and Collection Efficiency , 1987, IEEE Transactions on Industry Applications.

[12]  R. Bär.  TAR REMOVAL WITH A WET ELECTROSTATIC PRECIPITATOR (ESP); A PARAMETRIC STUDY , 2004 .

[13]  H. Tamon,et al.  Removal of Aromatic Compounds in Gas by Electron Attachment , 1998 .

[14]  I. Obernberger,et al.  Chemical properties of solid biofuels¿significance and impact , 2006 .

[15]  K. Thambimuthu,et al.  A critical review of syngas cleaning technologies — fundamental limitations and practical problems , 2008 .

[16]  A. Faaij,et al.  Exploration of the possibilities for production of Fischer Tropsch liquids and power via biomass gasification , 2002 .

[17]  A. J. Schwab,et al.  Numerical solution of nonstationary charge coupled problems , 1999 .

[18]  P. Atten,et al.  Simulation of corona discharge in point–plane configuration , 2004 .

[19]  J Muth.  Renewable fuels for advanced powertrains , 2006 .

[20]  Y. Gonthier,et al.  Numerical Model of Current–Voltage Curve for the Wire-Cylinder Electrostatic Precipitators in Negative Voltage in the Presence of Nonpolar Gases , 2010, IEEE Transactions on Plasma Science.

[21]  Kyriakos D. Panopoulos,et al.  Integrating biomass gasification with solid oxide fuel cells: Effect of real product gas tars, fluctuations and particulates on Ni-GDC anode , 2008 .

[22]  Kj Krzysztof Ptasinski,et al.  Tar removal from biomass-derived fuel gas by pulsed corona discharges , 2003 .

[23]  M. Dry,et al.  The Fischer–Tropsch process: 1950–2000 , 2002 .

[24]  E. A. COULSON,et al.  The Fischer–Tropsch Process , 1950, Nature.

[25]  Kj Krzysztof Ptasinski,et al.  A high-temperature pulsed corona plasma system for fuel gas cleaning , 2004 .

[26]  H. Hofbauer,et al.  Experimental investigation of a 125 kW twin-fire fixed bed gasification pilot plant and comparison to the results of a 2 MW combined heat and power plant (CHP) , 2008 .

[27]  Robert C. Brown,et al.  Ancillary equipment for biomass gasification , 2002 .

[28]  Jie He,et al.  Review of syngas production via biomass DFBGs , 2011 .

[29]  Lisbeth M. Ottosen,et al.  Institution of Chemical Engineers Symposium Series , 1999 .

[30]  M. Sanati,et al.  Physical and Chemical Characterization of Aerosol Particles Formed During the Thermochemical Conversion of Wood Pellets Using a Bubbling Fluidized Bed Gasifier , 2007 .

[31]  Andreas Hornung,et al.  HTHP syngas cleaning concept of two stage biomass gasification for FT synthesis , 2008 .

[32]  Harry J. White,et al.  Industrial Electrostatic Precipitation , 1963 .

[33]  Tetsuo Fuchino,et al.  Thermo-economic analysis for the optimal conceptual design of biomass gasification energy conversion systems , 2009 .