Experimental Verification of Current-Source Inverter With ZVS Commutation Circuit

This paper presents a current-source inverter suitable for high-voltage/high-power motor drives. This inverter uses thyristors as main switching devices and utilizes a zero-voltage-switching (ZVS) commutation circuit. It has the advantages of good motor power factor and self-startability. We have evaluated a test model of the proposed inverter and a motor and verified that the inverter operates at a motor power factor of one and that it can be started even when the motor speed is zero. Moreover, a six-phase synchronous motor was driven by two of these inverters; it was confirmed that they decreased the motor torque ripple and the harmonic component of the voltage source. In addition, we evaluated the operation of the ZVS commutation circuit by simulation and experiment and thus verified that turnoff loss depends mainly on the inductance of the ZVS commutation circuit and not on gate resistance. Moreover, when the switching device turns off the current, its voltage is almost zero. That is, even if the inductance is large, the peak voltage of the switching device is low and switching loss is small. Therefore, the ZVS commutation circuit can be easily composed because it does not need to be of low inductance. These results show that a large-capacity drive system can be easily achieved with the proposed inverter.

[1]  Scott D. Sudhoff,et al.  Start up performance of load-commutated inverter fed synchronous machine drives , 1995 .

[2]  D.C. Azbill,et al.  A case study of replacing steam turbines with LCI type variable speed drives , 1990, Conference Record of the 1990 IEEE Industry Applications Society Annual Meeting.

[3]  K. Matsuse,et al.  Performance of IGBTs Series Connection Technologies for Auxiliary Power Supply System , 2007, 2007 Power Conversion Conference - Nagoya.

[4]  A. Sapin,et al.  12-pulse LCI synchronous drive for a 20 MW compressor modeling, simulation and measurements , 2005, Fourtieth IAS Annual Meeting. Conference Record of the 2005 Industry Applications Conference, 2005..

[5]  P. Panagis,et al.  Comparison of state of the art multilevel inverters , 2008, 2008 IEEE Power Electronics Specialists Conference.

[6]  M. F. Benkhoris,et al.  Analysis of double star motor drives for electrical propulsion , 1999, IEMDC 1999.

[7]  Andrea Cavagnino,et al.  Efficiency Analysis of PWM Inverter Fed Three-Phase and Dual Three-Phase High Frequency Induction Machines for Low/Medium Power Applications , 2008, IEEE Transactions on Industrial Electronics.

[8]  Toshihiko Tanaka,et al.  A new approach to the capacitor-commutated converter for HVDC-a combined commutation-capacitor of active and passive capacitors , 2001, 2001 IEEE Power Engineering Society Winter Meeting. Conference Proceedings (Cat. No.01CH37194).

[9]  Zhang Chunli,et al.  Electromagnetic design of six-phase LCI-fed synchronous motor , 2001, ICEMS'2001. Proceedings of the Fifth International Conference on Electrical Machines and Systems (IEEE Cat. No.01EX501).

[10]  W. J. Frey.  Retrofit experience of an 8000 HP pipeline compressor variable speed drive , 1991, Industry Applications Society 38th Annual Petroleum and Chemical Industry Conference.

[11]  Peter K. Steimer,et al.  Five level GTO inverters for large induction motor drives , 1993, Conference Record of the 1993 IEEE Industry Applications Conference Twenty-Eighth IAS Annual Meeting.

[12]  Fang Zheng Peng,et al.  A multilevel voltage-source inverter with separate DC sources for static VAr generation , 1995, IAS '95. Conference Record of the 1995 IEEE Industry Applications Conference Thirtieth IAS Annual Meeting.

[13]  David C. Azbill,et al.  A case study of replacing steam turbines with LCI type variable speed drives , 1989, Industrial Applications Society, 36th Annual Petroleum and Chemical Industry Conference.

[14]  M. Fasching,et al.  Series connection of high voltage IGBT modules , 1998, Conference Record of 1998 IEEE Industry Applications Conference. Thirty-Third IAS Annual Meeting (Cat. No.98CH36242).

[15]  N. Okada,et al.  Series Connection of Snubberless IGBTs for 6.6 kV Transformerless Converters , 2007, 2007 Power Conversion Conference - Nagoya.

[16]  C. Li,et al.  lOkV 4H-SiC PiN Diodes Designed for Improved Switching Performance using Emitter Injection Control , 2007, Proceedings of the 19th International Symposium on Power Semiconductor Devices and IC's.

[17]  R. Withanage,et al.  Novel voltage balancing technique for series connection of IGBTs , 2007, 2007 European Conference on Power Electronics and Applications.

[18]  L.J.J. Offringa,et al.  New developments in power electronics for the flywheel system EMAFER , 1989, Proceedings of the 24th Intersociety Energy Conversion Engineering Conference.

[19]  R. Romary,et al.  Analytical determination of the double star synchronous machine commutating reactance , 1996 .

[20]  A. Piazzesi,et al.  Series connection of 3.3 kV IGBTs with active voltage balancing , 2004, 2004 IEEE 35th Annual Power Electronics Specialists Conference (IEEE Cat. No.04CH37551).

[21]  W. Fichtner,et al.  Design considerations for a 7 kV/3 kA GTO with transparent anode and buffer layer , 1996, PESC Record. 27th Annual IEEE Power Electronics Specialists Conference.

[22]  A. Cardoso,et al.  Condition monitoring and diagnostics of twelve-pulse LCI drive systems , 2005, 2005 5th IEEE International Symposium on Diagnostics for Electric Machines, Power Electronics and Drives.

[23]  Qingchun Zhang,et al.  State of the Art 10 kV NMOS Transistors , 2008, 2008 20th International Symposium on Power Semiconductor Devices and IC's.

[24]  Thomas A. Lipo,et al.  Analysis of a Novel Forced-Commutation Starting Scheme for a Load-Commutated Synchronous Motor Drive , 1979, IEEE Transactions on Industry Applications.

[25]  David A. Torrey,et al.  Series connection of IGBT's with active voltage balancing , 1999 .

[26]  F. Endrejat,et al.  Experience with new large adjustable speed drive technology for multiple synchronous motors , 2008, 2008 5th Petroleum and Chemical Industry Conference Europe - Electrical and Instrumentation Applications.

[27]  Jun Wang,et al.  New Improvement Results on 7.5 kV 4H-SiC p-IGBTs with Rdiff, on of 26 mΩ·cm2 at 25°C , 2007, Proceedings of the 19th International Symposium on Power Semiconductor Devices and IC's.

[28]  S. Bernet,et al.  Design and characteristics of reverse conducting 10-kV-IGCTs , 2008, 2008 IEEE Power Electronics Specialists Conference.