New basis for measuring the size distribution of bubbles

Abstract The use of air bubbles of varying size distribution in ore and wastewater treatment, including conventional (froth) and dissolved air flotation (DAF), Jameson flotation cell and Microcel (among others), has attracted much interest recently. These flotation processes are governed by the physical characteristics of the bubbles as well as the particles, and therefore it is necessary to investigate accurately the size distribution of bubbles that are generated. A new method was developed to measure the bubble size distribution based on the bubbles’ capture (without movement) combining microscopy with digital image processing procedures. The technique (LTM-BSizer) employs a sampler to draw bubbles, rising in a column, into a special viewing chamber and exposes them to a digital camera after they have decelerated and stopped. Thus common problems related to the movement of bubbles, namely focus, illumination, photographic speed and bubbles overlapping are all overcome. Results obtained are in good correlation with some values reported with the traditional image analysis method and show that using this technique accurate size distributions can be produced conveniently and efficiently. The influence of some operational parameters on the formation of bubbles was studied. It is believed that the bubble size measurement technique developed in this study will assist understanding and improvement of the DAF and conventional fines and ultrafines mineral flotation, from both theoretical and practical viewpoints.

[1]  Kari Heiskanen,et al.  Visual technique for measuring bubble size in flotation machines , 2002 .

[2]  Jaime Patricio Anfruns.  The flotation of small particles , 1976 .

[3]  Nigel N. Clark,et al.  Gas sampling from fluidized beds: A novel probe system , 1988 .

[4]  J. M. Burgess,et al.  A laser-based method for bubble parameter measurement in two-dimensional fluidised beds , 1987 .

[5]  Lev Filippov,et al.  Bubble spargers in column flotation: Adaptation to precipitate flotation , 2000 .

[6]  S. K. Bhaumik,et al.  Bubble size distribution in a flotation column , 1994 .

[7]  J. Blanken,et al.  Bubble size in flotation thickening , 1994 .

[8]  J. Laskowski,et al.  Effect of flotation frothers on bubble size and foam stability , 2002 .

[9]  Graeme J. Jameson,et al.  The effect of bubble size on the rate of flotation of fine particles , 1985 .

[10]  J. A. Finch,et al.  Wettability Effect on Bubble Formation at a Rigid Porous Sparger , 2002 .

[11]  Chris Aldrich,et al.  The effect of mothers on bubble size distributions in flotation pulp phases and surface froths , 2000 .

[12]  Th. F. Zabel,et al.  Flotation In Water Treatment , 1992 .

[13]  G. K. Sharma,et al.  BUBBLE DYNAMICS AND ELUTRIATION STUDIES IN GAS-FLUID1ZED BEDS , 1984 .

[14]  H. Unno,et al.  Size reduction of bubbles by orifice mixer , 1980 .

[15]  Mooyoung Han,et al.  Development of a new method of measuring bubble size , 2002 .

[16]  Jauregi,et al.  Colloidal gas aphrons: potential applications in biotechnology , 1999, Trends in biotechnology.

[17]  S. K. Nicol,et al.  Concentration of oil-in-water emulsion using the air-sparged hydrocyclone , 1993 .

[18]  B. K. Parekh,et al.  Advances in flotation technology , 1999 .

[19]  Nosa O. Egiebor,et al.  Frother effects on bubble size estimation in a flotation column , 1993 .

[20]  James K. Edzwald,et al.  Principles and applications of dissolved air flotation , 1995 .

[21]  James A. Finch,et al.  Estimation of Bubble Diameter in Flotation Columns from Drift Flux Analysis , 1988 .

[22]  D. A. Deglon,et al.  An evaluation of a direct method of bubble size distribution measurement in a laboratory batch flotation cell , 1994 .

[23]  James A. Finch,et al.  Technical note bubble size measurement in flotation machines , 2001 .

[24]  Emmanuel Manlapig,et al.  Studies on impeller type, impeller speed and air flow rate in an industrial scale flotation cell — Part 1: Effect on bubble size distribution , 1995 .

[25]  Haruo Kobayashi,et al.  LATERAL DISTRIBUTION OF BUBBLE SIZES IN TWO-DIMENSIONAL GAS-FLUIDIZED BED , 1975 .

[26]  G. R. Caicedo,et al.  A study on the behaviour of bubbles of a 2D gas–solid fluidized bed using digital image analysis , 2003 .

[27]  Anastasios I. Zouboulis,et al.  Adsorbing Flotation of Copper Hydroxo Precipitates by Pyrite Fines , 1992 .

[28]  Jacob H. Masliyah,et al.  A method of visualization and characterization of aggregate flow inside a separation vessel, Part 1. Size, shape and rise velocity of the aggregates , 1999 .

[29]  Roe-Hoan Yoon,et al.  The Application of MicrocelTM Column Flotation to Fine Coal Cleaning , 1992 .

[30]  Gary F. Bennett,et al.  The removal of oil from wastewater by air flotation: A review , 1988 .

[31]  J. Haarhoff,et al.  Behaviour of air injection nozzles in dissolved air flotation , 1995 .

[32]  J. Rubio,et al.  Overview of flotation as a wastewater treatment technique , 2002 .

[33]  E. W. Randall,et al.  A method for measuring the sizes of bubbles in two- and three-phase systems , 1989 .

[34]  Janusz S. Laskowski,et al.  Bubble coalescence and its effect on dynamic foam stability , 2002 .

[35]  Cyril T. O'Connor,et al.  Measurement of the effects of physical and chemical variables on bubble size , 1990 .

[36]  Paul Mavros,et al.  Innovations in flotation technology , 1992 .

[37]  Graeme J. Jameson,et al.  The development and application of the Jameson cell , 1991 .

[38]  J. Militzer,et al.  Bubble size and velocity measurement in gas—liquid systems: Application of fiber optic technique to pilot plant scale , 1995 .