RF power handling of capacitive RF MEMS devices

RF MEMS switches provide a low-cost, high-performance solution to many RF/microwave applications. In this paper, progress in characterizing capacitive MEMS devices under high RF power is presented. The switches tested demonstrated power handling capabilities of 510 mW for continuous RF power and 4 W for pulsed RF power. In addition, the reliability of these switches was tested at various power levels indicating that under continuous RF power, the lifetime is not affected until the 510 mW power level is reached. Once a power failure is observed, it is completely recoverable by lowering the RF power level below the threshold point. A description of the power failures and their associated operating conditions is presented.

[1]  K. Petersen.  Micromechanical membrane switches on silicon , 1979 .

[2]  Lawrence E. Larson,et al.  Micromachined microwave actuator (MIMAC) technology-a new tuning approach for microwave integrated circuits , 1991, IEEE 1991 Microwave and Millimeter-Wave Monolithic Circuits Symposium. Digest of Papers.

[3]  Xi-Qing Sun,et al.  A micro variable inductor chip using MEMS relays , 1997, Proceedings of International Solid State Sensors and Actuators Conference (Transducers '97).

[4]  S. Eshelman,et al.  Performance of low-loss RF MEMS capacitive switches , 1998 .

[5]  Gabriel M. Rebeiz,et al.  High-isolation CPW MEMS shunt switches. 1. Modeling , 2000 .

[6]  Gabriel M. Rebeiz,et al.  High-isolation CPW MEMS shunt switches. 2. Design , 2000 .

[7]  B. Pillans,et al.  Lifetime characterization of capacitive RF MEMS switches , 2001, 2001 IEEE MTT-S International Microwave Sympsoium Digest (Cat. No.01CH37157).