Single hole at constrained location for stress analysis in PCB plate bending

In this paper, simulation on the bending process of PCB during depaneling was done. The stress response during the bending process was evaluated using a computational program Ansys version 11. Two PCB plate model were developed: one of the model with single hole and other model without hole. The stress response of the two models were then compared. From the simulation, it has been observed that the value of stress response of the PCB increases with increasing displacement height. The PCB model with single hole exhibited higher stress compared to the PCB model without hole. Highest stress response was obtained at the displacement height of 5cm for both models.

[1]  Zhaowei Zhong,et al.  Modal analysis and dynamic responses of board level drop test , 2003, Proceedings of the 5th Electronics Packaging Technology Conference (EPTC 2003).

[2]  Rao Tummala,et al.  Fundamentals of Microsystems Packaging , 2001 .

[3]  S. W. Ricky Lee,et al.  Correlation Between the Strain on the Printed Circuit Board and the Stress in Chips for the Failure Prediction of Passive Components , 2005 .

[4]  D. Lau,et al.  Experimental testing and computational stress analysis of printed circuit board for the failure prediction of passive components under the depaneling load condition , 2005, Proceedings Electronic Components and Technology, 2005. ECTC '05..

[5]  Ping Yang,et al.  Life Predict and Simulation of the Copper Wire in Flexible Printed Circuit Board , 2011, 2011 Third International Conference on Measuring Technology and Mechatronics Automation.

[6]  Zhaowei Zhong,et al.  Novel numerical and experimental analysis of dynamic responses under board level drop test , 2004, 5th International Conference on Thermal and Mechanical Simulation and Experiments in Microelectronics and Microsystems, 2004. EuroSimE 2004. Proceedings of the.