Serial block face scanning electron microscopy (SBFSEM) is a powerful technique originally introduced by Leighton [1], substantially improved by Denk [2] and subsequently commercialized (Gatan Inc., Pleasanton, CA.). SBFSEM allows for the automated image acquisition of relatively large volumes of tissue at near nanometer-scale resolution, using a dry cutting ultramicrotome fitted into an SEM. In an automated process, a low voltage backscatter electron (BSE) image is obtained from the surface of an epoxy embedded tissue block face. The ultramicrotome then removes an ultra-thin section of tissue with a specially designed oscillating diamond knife (Diatome AG, Switzerland), and a block face image from the corresponding region is again obtained. This sequence is repeated over and over until the desired volume of tissue has been imaged. Although SBFSEM overcomes many obstacles routinely encountered with serial section TEM reconstruction, until recently there was a significant limitation to the resolution obtainable by this method compared to conventional TEM. This was due primarily to difficulties encountered using BSE imaging at low accelerating voltages. To overcome this we have developed a protocol for vastly increasing the heavy metal staining of specimens to improve BSE yield. This is accomplished by combining a variety of preexisting heavy metal staining methodologies not normally used together, including ferrocyanide-reduced osmium tetroxide, thiocarbohydrazide-osmium tetroxide (OTO), prolonged uranyl acetate treatment and en bloc lead aspartate staining. Using this approach, we demonstrate a dramatic improvement in image contrast and resolution from existing methods in a variety of specimens (Fig. 1).