Continuous cooling precipitation diagram of aluminium alloy AA7150 based on a new fast scanning calorimetry and interrupted quenching method

[1]  M. Weyland,et al.  Precipitation of a new platelet phase during the quenching of an Al-Zn-Mg-Cu alloy , 2016, Scientific Reports.

[2]  J. Drezet,et al.  Characterisation of precipitation upon cooling of an AA2618 Al–Cu–Mg alloy , 2016 .

[3]  P. Rometsch,et al.  Predicting the quench sensitivity of Al-Zn-Mg-Cu alloys: a model for linear cooling and strengthening , 2015 .

[4]  H. Y. Li,et al.  Development of non-linear continuous cooling precipitation diagram for Al–Zn–Mg–Cu alloy , 2015 .

[5]  J. Drezet,et al.  Quench induced residual stress prediction in heat treatable 7xxx aluminium alloy thick plates using Gleeble interrupted quench tests , 2015 .

[6]  Christoph Schick,et al.  Dissolution and Precipitation Behaviour during Continuous Heating of Al–Mg–Si Alloys in a Wide Range of Heating Rates , 2015, Materials.

[7]  C. Schick,et al.  Quench-induced precipitates in Al-Si alloys: Calorimetric determination of solute content and characterisation of microstructure , 2015 .

[8]  J. Drezet,et al.  Early precipitation during cooling of an Al-Zn-Mg-Cu alloy revealed by in situ small angle X-ray scattering , 2014 .

[9]  C. Schick,et al.  Continuous cooling precipitation diagram of high alloyed Al-Zn-Mg-Cu 7049A alloy , 2014 .

[10]  C. Schick,et al.  Development of continuous cooling precipitation diagrams for aluminium alloys AA7150 and AA7020 , 2014 .

[11]  P. Rometsch,et al.  Effect of recrystallisation on Al3Zr dispersoid behaviour in thick plates of aluminium alloy AA7150 , 2014, Journal of Materials Science.

[12]  Christoph Schick,et al.  Continuous cooling precipitation diagrams of Al-Mg-Si alloys , 2012 .

[13]  C. Schick,et al.  Precipitation enthalpy during cooling of aluminum alloys obtained from calorimetric reheating experiments , 2012 .

[14]  Z. Yin,et al.  Investigation of quench sensitivity and transformation kinetics during isothermal treatment in 6082 aluminum alloy , 2011 .

[15]  C. Schick,et al.  Fast scanning power compensated differential scanning nano-calorimeter: 1. The device , 2010 .

[16]  Christoph Schick,et al.  Recording of continuous cooling precipitation diagrams of aluminium alloys , 2009 .

[17]  Minfeng Chen,et al.  Influence of aging on quench sensitivity effect of 7055 aluminum alloy , 2008 .

[18]  C. Schick,et al.  Ultrafast thermal processing and nanocalorimetry at heating and cooling rates up to 1 MK/s. , 2007, The Review of scientific instruments.

[19]  V. Mathot,et al.  High-speed/high performance differential scanning calorimetry (HPer DSC): Temperature calibration in the heating and cooling mode and minimization of thermal lag , 2006 .

[20]  I. Polmear,et al.  Light Alloys: From Traditional Alloys to Nanocrystals , 2006 .

[21]  C. Schick,et al.  Non-adiabatic thin-film (chip) nanocalorimetry , 2005 .

[22]  Rafael Colás,et al.  Quench sensitivity of a heat treatable aluminum alloy , 2003 .

[23]  Elisabeth Aeby-Gautier,et al.  Precipitation sequences during quenching of the AA 7010 alloy , 2002 .

[24]  B. Goderis,et al.  High-Speed Calorimetry for the Study of the Kinetics of (De)vitrification, Crystallization, and Melting of Macromolecules † , 2002 .

[25]  R. Colás,et al.  Precipitation in a heat-treatable aluminum alloy cooled at different rates , 2001 .

[26]  P. Archambault,et al.  High temperature precipitation kinetics and TTT curve of a 7xxx alloy by in-situ electrical resistivity measurements and differential calorimetry , 2000 .

[27]  J. Hatch,et al.  Aluminum: Properties and Physical Metallurgy , 1984 .