Use of a bituminous mixture layer in high-speed line trackbeds

Abstract Feedback on the use of a sub-ballast bituminous layer in a ballasted high-speed line (HSL) is evaluated in this paper. Conclusions are drawn on the relation between the thermo-viscoelastic behaviour of bituminous materials and the improvement in maintenance needs observed on the studied HSL. The case study is a 3 km long experimental zone of the French East-European high-speed line (EE HSL) built with a bituminous mixture sub-ballast layer. In service since 2007, the EE HSL test section has required fewer maintenance operations compared to adjacent sections with conventional structure. Thermo-viscoelastic properties of a bituminous mixture were characterized to understand and explain the contribution of a bituminous sub-ballast layer to the track behaviour. Improved 3D complex modulus tests were performed on laboratory-compacted cylindrical specimens using sinusoidal loading. A constitutive model, called 2S2P1D (2 Springs, 2 Parabolic, 1 Dashpot), developed in the LTDS/ENTPE Laboratory, University of Lyon, was used to simulate the linear viscoelastic (LVE) behaviour of the tested material. The results were analysed in the light of the working conditions and typical loadings of the EE HSL. The results of this study contribute to the definition of an optimal design method for ballasted HSL tracks with bituminous sub-ballast layers.

[1]  Simon Pouget,et al.  Viscoelastic Behaviour Characterization of a Gap-graded Asphalt Mixture with SBS Polymer Modified Bitumen , 2015 .

[2]  Paulo Fonseca Teixeira,et al.  Optimisation model to schedule railway track renewal operations: a life-cycle cost approach , 2015 .

[3]  Simon Pouget,et al.  New method to obtain viscoelastic properties of bitumen blends from pure and reclaimed asphalt pavement binder constituents , 2014 .

[4]  Yanqing Zhao,et al.  A consistent approach for characterising asphalt concrete based on generalised Maxwell or Kelvin model , 2014 .

[5]  Simon Pouget,et al.  Time-temperature superposition principle for bituminous mixtures , 2009 .

[6]  C. Sauzéat,et al.  Linear viscoelastic behaviour of bituminous materials: From binders to mixes , 2004 .

[7]  Michael P. Wistuba,et al.  Comparison of rheological parameters of asphalt binders obtained from bending beam rheometer and dynamic shear rheometer at low temperatures , 2015 .

[8]  Rafiqul A. Tarefder,et al.  Laboratory investigation of asphalt concrete dynamic modulus testing on the criteria of meeting linear viscoelastic requirements , 2014 .

[9]  John Andrews,et al.  The effects of tamping on railway track geometry degradation , 2013 .

[10]  Cédric Sauzéat,et al.  Reclaimed asphalt pavement and additives’ influence on 3D linear behaviour of warm mix asphalts , 2015 .

[11]  Hakan Guler,et al.  Prediction of railway track geometry deterioration using artificial neural networks: a case study for Turkish state railways , 2014 .

[12]  Cédric Sauzéat,et al.  Complex modulus and complex Poisson’s ratio from cyclic and dynamic modal testing of asphalt concrete , 2015 .

[13]  Simon Pouget,et al.  Viscous Energy Dissipation in Asphalt Pavement Structures and Implication for Vehicle Fuel Consumption , 2012 .

[14]  Cédric Sauzéat,et al.  Nonlinearity, Heating, Fatigue and Thixotropy during Cyclic Loading of Asphalt Mixtures , 2011 .

[15]  J. Ferry.  Viscoelastic properties of polymers , 1961 .

[16]  Mingjing Fang,et al.  Numerical determination for optimal location of sub-track asphalt layer in high-speed rails , 2013 .

[17]  L. Francken,et al.  Stiffness testing for bituminous mixtures , 2001 .

[18]  Cédric Sauzéat,et al.  Three-Dimensional Linear Behavior of Bituminous Materials: Experiments and Modeling , 2007 .

[19]  M. R. Hainin,et al.  Modelling the rheological properties of bituminous binders using the 2S2P1D Model , 2013 .

[20]  V. Drnevich,et al.  SHEAR MODULUS AND DAMPING IN SOILS: DESIGN EQUATIONS AND CURVES , 1972 .

[21]  Ernest T. Selig,et al.  Track Geotechnology and Substructure Management , 1995 .

[22]  Gordon Airey,et al.  Combined bituminous binder and mixture linear rheological properties , 2004 .

[23]  H. Di Benedetto,et al.  Modeling of viscous bituminous wearing course materials on orthotropic steel deck , 2012 .

[24]  Cédric Sauzéat,et al.  Determination of bituminous mixtures linear properties using ultrasonic wave propagation , 2012 .

[25]  Cédric Sauzéat,et al.  Determination of thermal properties of asphalt mixtures as another output from cyclic tension-compression test , 2012 .