Computer Simulation Usage For Verification Of Deepened Shaft Artificial Bottom Construction

The paper presents the design verification methodology for so called artificial bottom of the mining shaft using computer simulation. Artificial bottom serves as the protection of the lower part of the shaft, in which works related to shaft deepening are carried out, against falling to the bottom of the shaft elements transported in its upper, active part. Model describing the phenomenon of artificial bottom stress is complex. In presented case it is a process of collision between object with a mass of 18 Mg model, falling into the shaft from a height of 800 m, and artificial bottom construction and inducted phenomenon of stress and strain wave propagation in various elements of construction. In this case load receiving elements are heavily deformed and many of them has to be destroyed. Therefore for construction verification computer simulation method has been chosen, conducted on the basis of subsequent crash tests, using the LS-DYNA program. The object of the research was an innovative solution of artificial bottom, developed by Central Mining Institute. A series of falling mass impact tests were performed, which had to prove the usefulness of applied solutions, as well as determine the influence of selected construction geometric parameters to effectiveness of transferring the impact load. This way, using the successive approximations method, the assumptions about the number of artificial bottom platforms and plate thickness used for additional coverage of one of the platforms were verified.