The Analysis of DC-link Voltage, Compensation Range, Cost, Reliability and Power Loss for Shunt (Hybrid) Active Power Filters

The design of shunt active power filters (APFs) and hybrid active power filters (HAPFs) with desirable characteristics are the major trend in the future, such as wide compensation range, high reliability, low cost, low switching loss, good tacking performance, etc. Over the past few decades, significant researches were focused on addressing the technical challenges associated with the parameter design, operation and control of the APFs and HAPFs. However, the comprehensive review of DC-link voltage, compensation range, cost, reliability, power loss and tracking performance has been barely studied. Therefore, the intent of this paper is to provide a clear picture of the selection of APFs and HAPFs based on DC-link voltage, compensation range, cost, reliability and power loss. The supreme one will be selected among different APFs and HAPFs by considering the DC-link voltage, compensation range, cost, reliability and power loss. Finally, the simulation results of different APFs and HAPFs will be provided to verify their compensation performances.

[1]  Man-Chung Wong,et al.  Cylindrical coordinate control of three-dimensional PWM technique in three-phase four-wired trilevel inverter , 2003 .

[2]  J.C. Das,et al.  Passive filters - potentialities and limitations , 2003, IEEE Transactions on Industry Applications.

[3]  Chi-Seng Lam,et al.  Selective Compensation of Distortion, Unbalanced and Reactive Power of a Thyristor-Controlled LC -Coupling Hybrid Active Power Filter (TCLC-HAPF) , 2017, IEEE Transactions on Power Electronics.

[4]  J Wurtz,et al.  Study of the pulse power supply unit for the four-horn system of the CERN to Frejus neutrino super beam , 2013 .

[5]  Gevork B. Gharehpetian,et al.  Reliability Considerations for Parallel Performance of Semiconductor Switches in High-Power Switching Power Supplies , 2009, IEEE Transactions on Industrial Electronics.

[6]  Ashwin M. Khambadkone,et al.  Reliability Analysis and Cost Optimization of Parallel-Inverter System , 2012, IEEE Transactions on Industrial Electronics.

[7]  Yi Tang,et al.  Parameter Design of a Novel Series-Parallel-Resonant LCL Filter for Single-Phase Half-Bridge Active Power Filters , 2017, IEEE Transactions on Power Electronics.

[8]  Chi-Seng Lam,et al.  Unbalanced Control Strategy for A Thyristor-Controlled LC-Coupling Hybrid Active Power Filter in Three-Phase Three-Wire Systems , 2017, IEEE Transactions on Power Electronics.

[9]  P. Venet,et al.  Recent Developments in Fault Detection and Power Loss Estimation of Electrolytic Capacitors , 2010, IEEE Transactions on Power Electronics.

[10]  Lei Wang,et al.  Non-linear adaptive hysteresis band pulse-width modulation control for hybrid active power filters to reduce switching loss , 2015 .

[11]  Chi-Seng Lam,et al.  Modeling and Parameter Design of Thyristor-Controlled LC-Coupled Hybrid Active Power Filter (TCLC-HAPF) for Unbalanced Compensation , 2017, IEEE Transactions on Industrial Electronics.

[12]  Kamal Al-Haddad,et al.  A Combination of Shunt Hybrid Power Filter and Thyristor-Controlled Reactor for Power Quality , 2014, IEEE Transactions on Industrial Electronics.

[13]  I.Dias Israel Sakaria.  A Hybrid Statcom With Wide Compensation Range And Low Dc Link Voltage , 2018 .

[14]  NingYi Dai,et al.  Analysis in the Effect of Co-phase Traction Railway HPQC Coupled Impedance on Its Compensation Capability and Impedance-Mapping Design Technique Based on Required Compensation Capability for Reduction in Operation Voltage , 2017, IEEE Transactions on Power Electronics.

[15]  A. E. Emanuel,et al.  Passive shunt harmonic filters for low and medium voltage: a cost comparison study , 1996 .

[16]  Kanungo Barada Mohanty,et al.  Improvement of Power Quality Using a Robust Hybrid Series Active Power Filter , 2017, IEEE Transactions on Power Electronics.

[17]  Frédéric Richardeau,et al.  Reliability Calculation of Multilevel Converters: Theory and Applications , 2013, IEEE Transactions on Industrial Electronics.

[18]  L.M. Tolbert,et al.  Power Electronics for Distributed Energy Systems and Transmission and Distribution Applications: Assessing the Technical Needs for Utility Applications , 2005 .

[19]  Chi-Seng Lam,et al.  Analysis, Control, and Design of a Hybrid Grid-Connected Inverter for Renewable Energy Generation With Power Quality Conditioning , 2018, IEEE Transactions on Power Electronics.

[20]  Jang-Mok Kim,et al.  Fault Diagnosis of DC-Link Capacitors in Three-Phase AC/DC PWM Converters by Online Estimation of Equivalent Series Resistance , 2013, IEEE Transactions on Industrial Electronics.

[21]  Chi-Seng Lam,et al.  Design of a Thyristor Controlled LC Compensator for Dynamic Reactive Power Compensation in Smart Grid , 2017, IEEE Transactions on Smart Grid.

[22]  Chi-Seng Lam,et al.  Adaptive Thyristor-Controlled LC-Hybrid Active Power Filter for Reactive Power and Current Harmonics Compensation With Switching Loss Reduction , 2017, IEEE Transactions on Power Electronics.