A 6.5-kV ESD-protected 3-5-GHz ultra-wideband BiCMOS low-noise amplifier using interstage gain roll-off compensation

Design and validation of an electrostatic discharge (ESD)-protected ultra-wideband low-noise amplifier (LNA) is presented in this paper. It features an interstage matching network for gain roll-off compensation to achieve a flat gain over its passband. Evaluated with a chip-on-board approach, the amplifier demonstrates a gain of 11.8 /spl plusmn/ 0.3 dB, minimum noise figure of 2.1 dB, and a group delay variation of /spl plusmn/30 ps from 3 to 5 GHz, even though it uses a less advanced 0.35-/spl mu/m BiCMOS technology. The LNA is protected against human body model ESD stress up to 6.5 kV. The measured input third-order intercept point at 4.5 GHz is -5.5 dBm. The core LNA draws 3 mA from a 3-V supply.

[1]  A.A. Abidi,et al.  A 3-10-GHz low-noise amplifier with wideband LC-ladder matching network , 2004, IEEE Journal of Solid-State Circuits.

[2]  Huei Wang,et al.  A 5.4-mW LNA using 0.35- /spl mu/m SiGe BiCMOS technology for 3.1-10.6-GHz UWB wireless receivers , 2005, 2005 IEEE Radio Frequency integrated Circuits (RFIC) Symposium - Digest of Papers.

[3]  S. Iida,et al.  A 3.1 to 5 GHz CMOS DSSS UWB transceiver for WPANs , 2005, ISSCC. 2005 IEEE International Digest of Technical Papers. Solid-State Circuits Conference, 2005..

[4]  A. Bevilacqua,et al.  An ultrawideband CMOS low-noise amplifier for 3.1-10.6-GHz wireless receivers , 2004, IEEE Journal of Solid-State Circuits.

[5]  R. Meyer,et al.  High-frequency nonlinearity analysis of common-emitter and differential-pair transconductance stages , 1998, IEEE J. Solid State Circuits.

[6]  J. L. Showell,et al.  A scalable high-frequency noise model for bipolar transistors with application to optimal transistor sizing for low-noise amplifier design , 1997 .

[7]  J.W. Gewartowski,et al.  Solid-state microwave amplifier design , 1982, Proceedings of the IEEE.

[8]  Hans-Martin Rein,et al.  Modeling substrate effects in the design of high-speed Si-bipolar ICs , 1996, IEEE J. Solid State Circuits.

[9]  Osama Shanaa,et al.  Frequency-scalable SiGe bipolar RF front-end design , 2001 .

[10]  C.-H. Lee,et al.  A very low power SiGe LNA for UWB application , 2005, IEEE MTT-S International Microwave Symposium Digest, 2005..

[11]  P. Kinget,et al.  Low power programmable-gain CMOS distributed LNA for ultra-wideband applications , 2005, Digest of Technical Papers. 2005 Symposium on VLSI Circuits, 2005..

[12]  Changwan Kim,et al.  An ultra-wideband CMOS low noise amplifier for 3-5-GHz UWB system , 2005, IEEE Journal of Solid-State Circuits.

[13]  Mohamed A. Y. Abdulla,et al.  Distortion Analysis in Analog Integrated Circuits , 2002 .

[14]  Anuj Batra,et al.  Multi-band OFDM Physical Layer Proposal , 2003 .

[15]  S. Andersson,et al.  Wideband LNA for a multistandard wireless receiver in 0.18 /spl mu/m CMOS , 2003, ESSCIRC 2004 - 29th European Solid-State Circuits Conference (IEEE Cat. No.03EX705).

[16]  K. Washio,et al.  A 3-10 GHz bandwidth low-noise and low-power amplifier for full-band UWB communications in 0.25- /spl mu/m SiGe BiCMOS technology , 2005, 2005 IEEE Radio Frequency integrated Circuits (RFIC) Symposium - Digest of Papers.