The nanogap Pirani-a pressure sensor with superior linearity in an atmospheric pressure range

We have designed and fabricated a surface micromachined Pirani pressure sensor with an extremely narrow gap between its heater and heatsink (substrate) with superior output linearity in the atmospheric pressure range. The gap size of the device has been reduced to 50 nm by using a layer of PECVD amorphous silicon as a sacrificial layer and a xenon difluoride (XeF2) gas phase etching technique. Such a narrow gap pushes the transition from molecular to continuum heat conduction to pressures beyond 200 kPa. The higher transition pressure increases the measurement range and sensitivity of the gauge in atmospheric pressures. The gas phase etching of the sacrificial layer eliminates stiction problems related to a wet etching process. The active area of the sensor is only a 6 × 50 µm2 microbridge anchored to the substrate at both ends. An innovative fabrication technique was developed which resulted in a virtually flat microbridge with improved mechanical robustness. This process enabled us to have a very well-controlled gap between the microbridge and the substrate. The device was tested in a constant heater temperature mode with pressure ranges from 0.1 to 720 kPa. The heater power was only 3 mW at 101 kPa (atmospheric pressure), which increased to about 8 mW at 720 kPa. The output sensitivity and nonlinearity of the device were 0.55% per kPa at 101 kPa and ±13% of the output full scale, respectively.