Analysis of optimal Reynolds number for developing laminar forced convection in double sine ducts based on entropy generation minimization principle

Abstract In the present paper, the entropy generation and optimal Reynolds number for developing forced convection in a double sine duct with various wall heat fluxes, which frequently occurs in plate heat exchangers, are studied based on the entropy generation minimization principle by analytical thermodynamic analysis as well as numerical investigation. According to the thermodynamic analysis, a very simple expression for the optimal Reynolds number for the double sine duct as a function of mass flow rate, wall heat flux, working fluid and geometric dimensions is proposed. In the numerical simulations, the investigated Reynolds number ( Re ) covers the range from 86 to 2000 and the wall heat flux ( q ″) varies as 160, 320 and 640 W/m 2 . From the numerical simulation of the developing laminar forced convection in the double sine duct, the effect of Reynolds number on entropy generation in the duct has been examined, through which the optimal Reynolds number with minimal entropy generation is detected. The optimal Reynolds number obtained from the analytical thermodynamic analysis is compared with the one from the numerical solutions and is verified to have a similar magnitude of entropy generation as the minimal entropy generation predicted by the numerical simulations. The optimal analysis provided in the present paper gives worthy information for heat exchanger design, since the thermal system could have the least irreversibility and best exergy utilization if the optimal Re can be used according to practical design conditions.

[1]  Kuen Ting,et al.  Entropy generation and thermodynamic optimization of fully developed laminar convection in a helical coil , 2005 .

[2]  S. Patankar.  Numerical Heat Transfer and Fluid Flow , 2018, Lecture Notes in Mechanical Engineering.

[3]  B. Launder,et al.  The numerical computation of turbulent flows , 1990 .

[4]  Shahzada Zaman Shuja,et al.  Optimal fin geometry based on exergoeconomic analysis for a pin-fin array with application to electronics cooling , 2002 .

[5]  K. Ting,et al.  Optimal Reynolds number for the fully developed laminar forced convection in a helical coiled tube , 2006 .

[6]  Ahmet Z. Sahin,et al.  Irreversibilities in various duct geometries with constant wall heat flux and laminar flow , 1998 .

[7]  R. A. Mashelkar,et al.  Heat Transfer Equipment Design , 1988 .

[8]  A. Bejan,et al.  Entropy Generation Through Heat and Fluid Flow , 1983 .

[9]  R. I. Soloukhin,et al.  Radiative heating of a fine-porous filled material , 1988 .

[10]  H. Martin,et al.  Friction factors for fully developed laminar flow in ducts confined by corrugated parallel walls , 1997 .

[11]  W. Focke,et al.  The effect of the corrugation inclination angle on the thermohydraulic performance of plate heat exchangers , 1985 .

[12]  Naresh Kumar,et al.  Second law optimization of convective heat transfer through a duct with constant heat flux , 1989 .

[13]  A. Sahin,et al.  Thermodynamics of laminar viscous flow through a duct subjected to constant heat flux , 1996 .

[14]  J. Ding,et al.  Analytical solutions for laminar fully developed flows in double-sine shaped ducts , 1996 .

[15]  J. Ding,et al.  Laminar flow heat transfer to viscous powerlaw fluids in double-sine ducts , 1997 .

[16]  H. Martin.  A theoretical approach to predict the performance of chevron-type plate heat exchangers , 1996 .