An NP Control Chart Using Double Inspections

Abstract The np control chart is used widely in Statistical Process Control (SPC) for attributes. It is difficult to design an np chart that simultaneously satisfies a requirement on false alarm rate and has high detection effectiveness. This is mainly because one is often unable to make the in-control Average Run Length ARL 0 of an np chart close to a specified or desired value. This article proposes a new np control chart which is able to overcome the problems suffered by the conventional np chart. It is called the Double Inspection (DI) np chart, because it uses a double inspection scheme to decide the process status (in control or out of control). The first inspection decides the process status according to the number of non-conforming units found in a sample; and the second inspection makes a decision based on the location of a particular non-conforming unit in the sample. The double inspection scheme makes the in-control ARL 0 very close to a specified value and the out-of-control Average Run Length ARL 1 quite small. As a result, the requirement on a false alarm rate is satisfied and the detection effectiveness also achieves a high level. Moreover, the DI np chart retains the operational simplicity of the np chart to a large degree and achieves the performance improvement without requiring extra inspection (testing whether a unit is conforming or not).