Board level reliability of a stacked CSP subjected to cyclic bending

Abstract Second (board) level reliability of a stacked chip scale package (SCSP) under cyclic bending is conducted to evaluate the structural integrity of solder interconnects. The test vehicle (on-board SCSP) is simply supported at both ends and subjected to repetitive deflection in the middle (three-point bend). Cyclic deformation histories such as sinusoidal, triangular, and square waveforms are examined. Tremendous joint damage is observed as square-wave loading history was applied. Approximately 80% fatigue life degradation is found by bending several thermally aged samples having Ni/Au surface finish on Cu pads of package substrates and printed circuit boards. The observed failure mode is a brittle type fracture of intermetallic compound system, which is also known as effects of solder embrittlement. Measured fatigue life is characterized by two-parameter Weibull model with cumulative damage plot for each test condition. In addition to the comparisons of characteristic fatigue life for various package configuration and cyclic bending conditions, failure analysis is also employed to identify failure sites and mechanisms such as crack initiation and continuous growth to the complete fracture of solder joints.

[1]  P. J. Zheng,et al.  Thermal cyclic fatigue of the interconnect of a flex-type BGA , 2000, 2000 Proceedings. 50th Electronic Components and Technology Conference (Cat. No.00CH37070).

[2]  M. Kaufmann,et al.  Brittle interfacial fracture of PBGA packages soldered on electroless nickel/immersion gold , 1998, 1998 Proceedings. 48th Electronic Components and Technology Conference (Cat. No.98CH36206).

[3]  S. C. Hung,et al.  An experimental study of failure and fatigue life of a stacked CSP subjected to cyclic bending , 2001, 2001 Proceedings. 51st Electronic Components and Technology Conference (Cat. No.01CH37220).

[4]  Yasuhisa Yamaji,et al.  Board level reliability of CSP , 1998, 1998 Proceedings. 48th Electronic Components and Technology Conference (Cat. No.98CH36206).

[5]  J. Lau,et al.  Solder Joint Reliability of BGA, CSP, Flip Chip, and Fine Pitch SMT Assemblies , 1996 .

[6]  M. Amagai,et al.  Chip scale package (CSP) solder joint reliability and modeling , 1999, 1998 IEEE International Reliability Physics Symposium Proceedings. 36th Annual (Cat. No.98CH36173).

[7]  Lo-Soun Su,et al.  On thermal stresses and reliability of a PBGA chip scale package , 1998, 1998 Proceedings. 48th Electronic Components and Technology Conference (Cat. No.98CH36206).

[8]  S. C. Hung,et al.  Board level reliability of Chip scale packages , 1999 .

[9]  J. H. Lau,et al.  Solder joint reliability of flip chip and plastic ball grid array assemblies under thermal, mechanical, and vibrational conditions , 1996 .

[10]  S. H. Ho,et al.  On the reliability and failure of PBGA interconnects under bending cyclic test , 2000 .

[11]  Larry Leicht,et al.  Mechanical cycling fatigue of PBGA package interconnects , 2000 .