NUMERICAL MODELING OF CATALYTIC IGNITION

Catalytic ignition of CH4, CO, and H2 oxidation on platinum and palladium at atmospheric pressure is studied numerically. Two simple configurations are simulated: the stagnation flow field over a catalytically active foil and a chemical reactor with a catalytically active wire inside. The simulation includes detailed reaction mechanisms for the gas phase and for the surface. The gas-phase transport and its coupling to the surface is described using a simplified multicomponent model. The catalyst is characterized by its temperature and its coverage by adsorbed species. The dependence of the ignition temperature on the fuel/oxygen ratio is calculated and compared with experimental results. The ignition temperature of CH4 oxidation decreases with increasing CH4/O2 ratio, whereas the ignition temperature for the oxidation of H2 and CO increases with increasing fuel/oxygen ratio. The kinetic data for adsorption and desorption are found to be critical for the ignition process. They determine the dependence of the ignition temperature on the fuel/oxygen ratio. A sensitivity analysis leads to the rate-determining steps of the surface reaction mechanism. The bistable ignition behavior observed experimentally for lean H2/O2 mixtures on palladium is reproduced numerically. The abrupt transition from a kinetically controlled system before ignition to one controlled by mass transport after ignition is described by the time-dependent codes applied.

[1]  V. Matolín,et al.  SSIMS and TDS investigation of CO adsorption on Pd(111) during CO and O2 exposure , 1985 .

[2]  T. Engel.  A molecular beam investigation of He, CO, and O2 scattering from Pd(111) , 1978 .

[3]  W. R. Williams,et al.  Bifurcation behavior in homogeneous-heterogeneous combustion: I. Experimental results over platinum☆ , 1991 .

[4]  K. Christmann.  The interaction of hydrogen with metal surfaces of two-fold symmetry , 1989 .

[5]  A. Winkler,et al.  Wide range nozzle beam adsorption data for the systems H2/nickel and H2/Pd(100) , 1989 .

[6]  S. Oyama,et al.  Heterogeneous Hydrocarbon Oxidation , 1996 .

[7]  Michael J. Pilling,et al.  Evaluated Kinetic Data for Combustion Modelling , 1992 .

[8]  E. Fridell,et al.  An experimental study of the kinetics of OH and H2O formation on Pt in the H2 + O2 reaction , 1989 .

[9]  Frank Behrendt,et al.  Modelling and simulation of heterogeneous oxidation of methane on a platinum foil , 1994 .

[10]  G. Ertl,et al.  Adsorption of hydrogen on Pd(100) , 1980 .

[11]  J. Sato,et al.  Surface kinetics for catalytic combustion of hydrogen-air mixtures on platinum at atmospheric pressure in stagnation flows , 1995 .

[12]  R. Madix,et al.  The adsorption of H2O on clean and oxygen-covered pd(100): Formation and reaction of OH groups , 1984 .

[13]  Robert J. Kee,et al.  A model of elementary chemistry and fluid mechanics in the combustion of hydrogen on platinum surfaces , 1994 .

[14]  B. Kasemo,et al.  The critical condition for catalytic ignition. H2/O2 on Pt , 1993 .

[15]  Chung King Law,et al.  Catalytic ignition of fuel/oxygen/nitrogen mixtures over platinum , 1986 .

[16]  Ulrich Maas,et al.  Ignition processes in hydrogenoxygen mixtures , 1988 .

[17]  R. Greif,et al.  A Numerical Model of the Flow and Heat Transfer in a Rotating Disk Chemical Vapor Deposition Reactor , 1987 .

[18]  P. Deuflhard,et al.  One-step and extrapolation methods for differential-algebraic systems , 1987 .