A case study on the calibration of the k–ω SST (shear stress transport) turbulence model for small scale wind turbines designed with cambered and symmetrical airfoils

This work presents a calibration study of the k–ω SST turbulence model for small scale wind turbines. To accomplish this, two different sets of blades were designed, built, tested and simulated. The first set applied the NACA 0012 and the second the NACA 4412 airfoil. The numerical investigation was taken using the CFD (computational fluid dynamics) code OpenFOAM and the turbulence model was calibrated testing several values for the β∗, including its canonical value, 0.09. The numerical calibration (the main contribution of this paper), extended previous results, which stated that different β∗ values could calibrate the k–ω SST turbulence model for small wind turbines, mainly for the drag effects. The study broadened this conclusion, once the model was calibrated for a quite wide range of tip speed ratio values, from the turbine startup (λ = 0) until its highest experimental value (λ ≅ 8). As a secondary contribution, the results show that the model could be adjusted to simulate average field data, even though these being subject to its inherent variabilities. The main conclusion was that, for the sets of blades studied, the lowest RMSE value was obtained for β∗ = 0.27.

[1]  Shun Kang,et al.  Stochastic performance evaluation of horizontal axis wind turbine blades using non-deterministic CFD simulations , 2014 .

[2]  Ervin Bossanyi,et al.  Wind Energy Handbook , 2001 .

[3]  Takao Maeda,et al.  Effect of number of blades on aerodynamic forces on a straight-bladed Vertical Axis Wind Turbine , 2015 .

[4]  Alessandro Parente,et al.  RANS simulation of ABL flow over complex terrains applying an enhanced k-ε model and wall function formulation , 2012 .

[5]  James F. Manwell,et al.  Book Review: Wind Energy Explained: Theory, Design and Application , 2006 .

[6]  John E. Fletcher,et al.  The methodology for aerodynamic study on a small domestic wind turbine with scoop , 2008, WCE 2008.

[7]  Peter Freere,et al.  Small wind turbines with timber blades for developing countries: Materials choice, development, installation and experiences , 2011 .

[8]  D. Wilcox.  Turbulence modeling for CFD , 1993 .

[9]  A. John Mallinckrodt,et al.  Computational Fluid Dynamics: An Introduction , 2012 .

[10]  Carla Freitas de Andrade,et al.  Comparison of seven numerical methods for determining Weibull parameters for wind energy generation in the northeast region of Brazil , 2012 .

[11]  Gábor Janiga,et al.  Comparative analysis of turbulence models for the aerodynamic simulation of H-Darrieus rotors , 2015 .

[12]  David Wood,et al.  The starting and low wind speed behaviour of a small horizontal axis wind turbine , 2004 .

[13]  Javier Bartolome Calvo,et al.  A new extension for k–ω turbulence models to account for wall roughness , 2009 .

[14]  Hiroshi Taniguchi,et al.  Theoretical and experimental study on the aerodynamic characteristics of a horizontal axis wind turbine , 2005 .

[15]  Aleksandar Jemcov,et al.  OpenFOAM: A C++ Library for Complex Physics Simulations , 2007 .

[16]  P. A. Costa Rocha,et al.  k–ω SST (shear stress transport) turbulence model calibration: A case study on a small scale horizontal axis wind turbine , 2014 .

[17]  Mohammad Tariq Iqbal,et al.  Reliability analysis of grid connected small wind turbine power electronics , 2009 .

[18]  M. Rafiuddin Ahmed,et al.  Blade design and performance testing of a small wind turbine rotor for low wind speed applications , 2013 .

[19]  Mohamed S. Gaith,et al.  Aerodynamics performance of continuously variable speed horizontal axis wind turbine with optimal blades , 2014 .

[20]  Weeratunge Malalasekera,et al.  An introduction to computational fluid dynamics - the finite volume method , 2007 .

[21]  Andrei Dragomirescu,et al.  Performance assessment of a small wind turbine with crossflow runner by numerical simulations , 2011 .

[22]  Michael S. Selig,et al.  Low Reynolds Number Airfoils for Small Horizontal Axis Wind Thrbines , 1997 .

[23]  Francesco Balduzzi,et al.  Microeolic turbines in the built environment: Influence of the installation site on the potential energy yield , 2012 .

[24]  Brian A. Fleck,et al.  Comparative life-cycle assessment of a small wind turbine for residential off-grid use , 2009 .

[25]  Sriram Srinivasan,et al.  Dynamic wind estimation based control for small wind turbines , 2013 .

[26]  Zdenko Šimić,et al.  Small wind turbines – A unique segment of the wind power market , 2013 .

[27]  Leonardo Bergami,et al.  Analysis of the furling behavior of small wind turbines , 2010 .

[28]  Aerodynamic performance of NACA four-digit profiles in small-scale wind turbines for small farms , 2015 .

[29]  Mulualem G. Gebreslassie,et al.  Numerical simulation of a new type of cross flow tidal turbine using OpenFOAM – Part I: Calibration of energy extraction , 2013 .

[30]  Paulo Alexandre Costa Rocha,et al.  An efficiency comparison of numerical methods for determining Weibull parameters for wind energy applications: A new approach applied to the northeast region of Brazil , 2014 .

[31]  Brian Vick,et al.  Effect of blade flutter and electrical loading on small wind turbine noise , 2013 .

[32]  Derek B. Ingham,et al.  Computational fluid dynamics (CFD) mesh independency techniques for a straight blade vertical axis wind turbine , 2013 .

[34]  Yuwei Li,et al.  Dynamic overset CFD simulations of wind turbine aerodynamics , 2012 .

[35]  F. Trivellato,et al.  The ideal power curve of small wind turbines from field data , 2012 .

[36]  Milutin Jovanovic,et al.  Generic maximum power point tracking controller for small-scale wind turbines , 2012 .

[37]  Sungjun Joo,et al.  Aerodynamic characteristics of two-bladed H-Darrieus at various solidities and rotating speeds , 2015 .

[38]  G. F. Naterer,et al.  Small wind turbine energy policies for residential and small business usage in Ontario, Canada , 2011 .

[39]  A. Gosman,et al.  High resolution NVD differencing scheme for arbitrarily unstructured meshes , 1999 .

[40]  S Gómez-Iradi,et al.  Computational fluid dynamics investigation of some wind turbine rotor design parameters , 2008 .

[41]  David Wood,et al.  Research and development issues for small wind turbines , 1999 .

[42]  Michael Conlon,et al.  THE PROGRESSIVE DEVELOPMENT OF TURBULENCE STATISTICS AND ITS IMPACT ON WIND POWER PREDICTABILITY , 2014 .

[43]  William David Lubitz,et al.  Impact of ambient turbulence on performance of a small wind turbine , 2011 .

[44]  Kazumasa Ameku,et al.  Design of a 3 kW wind turbine generator with thin airfoil blades , 2008 .

[45]  S. M. Habali,et al.  Local design, testing and manufacturing of small mixed airfoil wind turbine blades of glass fiber reinforced plastics: Part II: Manufacturing of the blade and rotor , 2000 .

[46]  Hrvoje Jasak,et al.  A tensorial approach to computational continuum mechanics using object-oriented techniques , 1998 .

[47]  Hrvoje Jasak,et al.  Error analysis and estimation for the finite volume method with applications to fluid flows , 1996 .

[48]  F. Menter.  Two-equation eddy-viscosity turbulence models for engineering applications , 1994 .