Investigation on the use of a novel regenerative flow turbine in a micro-scale Organic Rankine Cycle unit

Abstract Reliable and low-cost expanders are fundamental for the competitiveness of small-scale Organic Rankine Cycle (ORC) plants using low-temperature heat sources. Regenerative flow turbines (RFTs) can be considered a low-cost and viable alternative expander, yet their performance needs to be fully investigated. Therefore, the use of an RFT in a micro-scale ORC test bench is investigated in this work through a modelling study. Specifically, three-dimensional CFD simulations are carried out to assess the performance of the considered expander with varying operating conditions and a numerical model of a non-regenerative, small-scale ORC system is developed to investigate its potential in waste heat recovery (WHR) applications. Using R245fa as the working fluid, the CFD analysis shows that the expander achieves a maximum total-to-static isentropic efficiency of about 44% in the investigated operating range. The small-scale ORC system has a net output power in the range 100–600 W and a net cycle efficiency of 1–2.3%. Moreover, a comparison with two scroll expanders having different built-in volume ratios shows that the RFT operates with higher isentropic efficiencies in low mass flow rates and pressure ratios thus highlighting its suitability for low-temperature WHR applications, especially when considerable fluctuations of the heat source are expected.

[1]  Vincent Lemort,et al.  Experimental study on an open-drive scroll expander integrated into an ORC (Organic Rankine Cycle) system with R245fa as working fluid , 2013 .

[2]  Vincent Lemort,et al.  Experimental characterization of a hermetic scroll expander for use in a micro-scale Rankine cycle , 2012 .

[3]  Vincent Lemort,et al.  Working fluid selection and operating maps for Organic Rankine Cycle expansion machines , 2012 .

[4]  Marco Astolfi,et al.  Technical options for organic rankine cycle systems , 2017 .

[5]  Yunxia Liu,et al.  Expansion devices for organic Rankine cycle (ORC) using in low temperature heat recovery: A review , 2019, Energy Conversion and Management.

[6]  M. Renzi,et al.  Experimental analysis of a small-scale scroll expander for low-temperature waste heat recovery in Organic Rankine Cycle , 2019, Energy.

[7]  Thomas Scanlon,et al.  Design study of a regenerative pump using one-dimensional and three-dimensional numerical techniques , 2012 .

[8]  Roberto Capata,et al.  Expander selection for an on board ORC energy recovery system , 2017 .

[9]  T Meakhail,et al.  An improved theory for regenerative pump performance , 2005 .

[10]  Mauro Villarini,et al.  Numerical Investigation on the Performance of a Regenerative Flow Turbine for Small-Scale Organic Rankine Cycle Systems , 2019, Journal of Engineering for Gas Turbines and Power.

[11]  Z. Ayub,et al.  Experimental investigation of single phase convective heat transfer coefficient in a corrugated plate heat exchanger for multiple plate configurations , 2010 .

[12]  E. Galloni,et al.  Design and experimental analysis of a mini ORC (organic Rankine cycle) power plant based on R245fa working fluid , 2015 .

[13]  Muhammad Imran,et al.  Volumetric expanders for low grade heat and waste heat recovery applications , 2016 .

[14]  Matthew Stickland,et al.  A One-Dimensional Numerical Model for the Momentum Exchange in Regenerative Pumps , 2011 .

[15]  A. Mahmoudi,et al.  A recent review of waste heat recovery by Organic Rankine Cycle , 2018, Applied Thermal Engineering.

[16]  J. Thome,et al.  Flow boiling and frictional pressure gradients in plate heat exchangers. Part 2: Comparison of literature methods to database and new prediction methods , 2016 .

[17]  James E. Braun,et al.  Experimental and numerical analyses of a 5 kWe oil-free open-drive scroll expander for small-scale organic Rankine cycle (ORC) applications , 2018, Applied Energy.

[18]  E. Macchi,et al.  Theoretical basis of the Organic Rankine Cycle , 2017 .

[19]  Thomas Scanlon,et al.  Development of a regenerative pump impeller using rapid manufacturing techniques , 2010 .

[20]  Y. Duan.  Parametric Optimization And Thermodynamic Performance Comparison Of Single-Pressure And Dual-Pressure Evaporation Organic Rankine Cycles , 2018 .

[21]  George A. Aggidis,et al.  Regenerative liquid ring pumps review and advances on design and performance , 2016 .

[22]  Ruzhu Wang,et al.  Simulation and experiments on an ORC system with different scroll expanders based on energy and exergy analysis , 2015 .

[23]  Ahmed M. Soliman,et al.  A review on solar Rankine cycles: Working fluids, applications, and cycle modifications , 2018 .

[24]  Abraham Engeda,et al.  THEORY AND DESIGN OF THE REGENERATIVE FLOW COMPRESSOR , 2003 .

[25]  Abraham Engeda,et al.  A modified theory for the flow mechanism in a regenerative flow pump , 2003 .

[26]  Marco Badami,et al.  Theoretical model with experimental validation of a regenerative blower for hydrogen recirculation in a PEM fuel cell system , 2010 .

[27]  Minggao Ouyang,et al.  Study of working fluid selection of organic Rankine cycle (ORC) for engine waste heat recovery , 2011 .

[28]  Giampaolo Manfrida,et al.  An upgraded Tesla turbine concept for ORC applications , 2018, Energy.

[29]  A. Riasi,et al.  Parametric study and performance improvement of regenerative flow pump considering the modification in blade and casing geometry , 2017 .

[30]  Anthony M. Jacobi,et al.  Heat transfer correlations for single-phase flow in plate heat exchangers based on experimental data , 2017 .

[31]  Vincent Lemort,et al.  Experimental investigation and optimal performance assessment of four volumetric expanders (scroll, screw, piston and roots) tested in a small-scale organic Rankine cycle system , 2018, Energy.

[32]  Carlo M. Bartolini,et al.  Experimental Analysis of a Small Prototype of Peripheral Turbine for Decompression of Natural Gas , 1996 .

[33]  Vincent Lemort,et al.  Testing and modeling a scroll expander integrated into an Organic Rankine Cycle , 2009 .

[34]  S. L. Dixon,et al.  Fluid mechanics, thermodynamics of turbomachinery , 1966 .

[35]  Claudio Zilio,et al.  A new computational procedure for refrigerant condensation inside herringbone-type Brazed Plate Heat Exchangers , 2015 .

[36]  Abraham Engeda,et al.  Current Status, Design and Performance Trends for the Regenerative Flow Compressors and Pumps , 2002 .

[37]  I S Yoo,et al.  Improved momentum exchange theory for incompressible regenerative turbomachines , 2005 .

[38]  Nilla Karlsen-Davies.  Computational and experimental analysis of the effects of manufacturing tolerances on the performance of a regenerative liquid ring pump , 2017 .

[39]  Vincent Lemort,et al.  Experimental investigation of an Organic Rankine Cycle Tesla turbine working with R1233zd(E) , 2020 .

[40]  Muhammad Imran,et al.  Design and experimental investigation of a 1 kW organic Rankine cycle system using R245fa as working fluid for low-grade waste heat recovery from steam , 2015 .

[41]  Vincent Lemort,et al.  Positive displacement expanders for Organic Rankine Cycle systems , 2017 .