Numerical simulation of high-temperature gas flows in a Millimeter-Scale thruster

High-temperature nozzle flows at low Reynolds numbers are studied numerically by the direct simulation Monte Carlo method. Modeling results are compared with the experimental data on the specific impulse efficiency of a heated nitrogen flow at Re = 1.78 X 10 2 -4.09 x 102. Good agreement between modeling and data was observed for nonadiabatic wall conditions. The relative influence of three major thrust loss factors-flow divergence, surface friction, and heat transfer in axisymmetric and three-dimensional nozzles-is estimated for stagnation temperatures of 300, 1000, and 2000 K and Re = 2.05 x 10 2 . For a stagnation temperature of 1000 K, the specific impulse is 50% larger than in the cold gas case (300 K), whereas the efficiency is 10% lower as a result of heat-transfer losses of the same magnitude as friction losses. Axisymmetric conical nozzle thrust performance was studied for a hydrogen-air propellant over a range of Re=2 ( 10 2 -2 x 10 3 . It is found that vibrational relaxation could be a significant factor in the simulation of such flows.

[1]  Kenneth S. Breuer,et al.  Viscous Effects in Supersonic MEMS-Fabricated Micronozzles , 1998, Micro-Electro-Mechanical Systems (MEMS).

[2]  N. Jiang,et al.  Comparison of molecular tagging velocimetry data and direct simulation Monte Carlo simulations in supersonic micro jet flows , 2003 .

[3]  Eli Reshotko,et al.  The Compressible Laminar Boundary Layer with Heat Transfer and Arbitrary Pressure Gradient , 1956 .

[4]  Lyle N. Long,et al.  Direct simulation Monte Carlo model of Low Reynolds number nozzle flows , 1994 .

[5]  Claus Borgnakke,et al.  Statistical collision model for Monte Carlo simulation of polyatomic gas mixture , 1975 .

[6]  S. V. Rogasinsky,et al.  Analysis of numerical techniques of the direct simulation Monte Carlo method in the rarefied gas dynamics , 1988 .

[7]  Forrest E. Lumpkin,et al.  Resolution of differences between collision number definitions in particle and continuum simulations , 1991 .

[8]  Mikhail S. Ivanov,et al.  Numerical study of 2D/3D micronozzle flows , 2002 .

[9]  Iain D. Boyd,et al.  Particle Simulations of Helium Microthruster Flows , 1994 .

[10]  Hassan Hassan,et al.  Rates of thermal relaxation in direct simulation Monte Carlo methods , 1994 .

[11]  Andrew D. Ketsdever,et al.  Numerical Study of Cold Gas Micronozzle Flows , 1999 .

[12]  Hiroaki Matsumoto,et al.  Variable soft sphere molecular model for inverse-power-law or Lennard-Jones potential , 1991 .

[13]  Mikhail S. Ivanov,et al.  Statistical simulation of reactive rarefied flows - Numerical approach and applications , 1998 .

[14]  Kenneth J. Witt,et al.  Low-Density Nozzle Flow by the Direct Simulation Monte Carlo and Continuum Methods , 1995 .

[15]  K. Breuer,et al.  MEMS, microengineering and aerospace systems , 1999 .

[16]  Roger C. Millikan,et al.  Systematics of Vibrational Relaxation , 1963 .

[17]  M. Schmidt,et al.  Microfabrication of high-temperature silicon devices using wafer bonding and deep reactive ion etching , 1999 .

[18]  J. G. Parker.  Rotational and Vibrational Relaxation in Diatomic Gases , 1959 .