A Momentum-Zonal Model for Predicting Zone Airflow and Temperature Distributions to Enhance Building Load and Energy Simulations

Building load and energy simulation programs based on the complete-mixing air model fail to consider the impact of nonuniform air temperature distributions. A momentum zonal model based on the Eüler equation has been developed to enhance building load and energy simulations by predicting indoor airflows and temperatures. This paper shows some validation exercises by comparing model results to measurements and computational fluid dynamics. The model was found to predict thermal stratification conditions reasonably well and to err on the side of complete mixing. The model has been coupled to the heat balance model and tested on load calculations. Results for cooling and heating loads are compared to the traditional complete-mixing model with minor effects on total load but important differences in air system flow rate and control options. Total computation times for load calculations were two orders of magnitude higher using the momentum zonal model compared to traditional complete mixing.

[1]  Christian Inard,et al.  Thermal experiments of full-scale dwelling cells in artificial climatic conditions , 1987 .

[2]  Mats Sandberg,et al.  Vertical Temperature Profiles in Rooms Ventilated by Displacement: Full‐Scale Measurement and Nodal Modelling , 1992 .

[3]  Fariborz Haghighat,et al.  Development and validation of a zonal model — POMA , 2001 .

[4]  Laurent Mora,et al.  SIM_ZONAL: SOFTWARE EVALUATING INDOOR TEMPERATURE DISTRIBUTIONS AND AIR MOVEMENTS FOR RAPID APPRAISALS-FIRST APPLICATION TO AN CELL , 2001 .

[5]  Francis Allard,et al.  About the construction of autonomous zonal models , 2001 .

[6]  Simon J. Rees,et al.  Modelling of displacement ventilation and chilled ceiling systems using nodal models , 1998 .

[7]  Refrigerating.  2001 ASHRAE handbook : fundamentals , 2001 .

[8]  Ian Beausoleil-Morrison,et al.  The adaptive coupling of heat and air flow modelling within dynamic whole-building simulation , 2000 .

[9]  James W. Axley,et al.  Surface-drag flow relations for zonal modeling , 2001 .

[10]  Qingyan Chen,et al.  STRATEGIES FOR COUPLING ENERGY SIMULATION AND COMPUTATIONAL FLUID DYNAMICS PROGRAMS , 2001 .

[11]  Etienne Wurtz,et al.  Two- and three-dimensional natural and mixed convection simulation using modular zonal models in buildings , 1999 .

[12]  Refrigerating.  ASHRAE handbook of fundamentals , 1967 .

[13]  Cezar O.R. Negrão,et al.  CONFLATION OF COMPUTATIONAL FLUID DYNAMICS AND BUILDING THERMAL SIMULATION , 1995 .

[14]  Nobukazu Kobayashi.  Floor-supply displacement ventilation system , 2001 .

[15]  Brent T. Griffith,et al.  Incorporating nodal and zonal room air models into building energy calculation procedures , 2002 .

[16]  Christian Inard,et al.  Prediction of air temperature distribution in buildings with a zonal model , 1996 .