Release of TiO2 from paints containing pigment-TiO2 or nano-TiO2 by weathering.

The release of nanomaterials from products and applications that are used by industry and consumers has only been studied to a very limited extent. The amount and the characteristics of the released particles determine the potential environmental exposure. In this work we investigated the release of Ti from paints containing pigment-TiO2 and nano-TiO2. Panels covered with paint with and without nano-TiO2 were exposed to simulated weathering by sunlight and rain in climate chambers. The same paints were also studied in small-scale leaching tests to elucidate the influence of various parameters on the release such as composition of water, type of support and UV-light. Under all conditions we only observed a very low release close to background values, less than 1.5 μg l(-1) in the climate chamber over 113 irrigations per drying cycle and between 0.5 and 14 μg l(-1) in the leaching tests, with the highest concentrations observed after prolonged UV-exposure. The actual release of Ti over the 113 weathering cycles was only 0.007% of the total Ti, indicating that TiO2 was strongly bound in the paint. Extraction of UV-exposed and then milled paint resulted in about 100-times larger release of Ti from the nano-TiO2 containing paint whereas the paint with only pigment-TiO2 did not show this increase. This indicated that the release of Ti from the paints is an effect of the addition of nano-TiO2, either by photocatalytic degradation of the organic paint matrix (observed by electron microscopic imaging of the paint surface) or by direct release of nano-TiO2. Our work suggests that paints containing nano-TiO2 may release only very limited amounts of materials into the environment, at least over the time-scales investigated in this work.

[1]  Sverker Molander,et al.  Particle Flow Analysis , 2012 .

[2]  Maria Dusinska,et al.  The importance of life cycle concepts for the development of safe nanoproducts. , 2010, Toxicology.

[3]  C. Tyler,et al.  Review: Do engineered nanoparticles pose a significant threat to the aquatic environment? , 2010, Critical reviews in toxicology.

[4]  Michael Burkhardt,et al.  Release of silver nanoparticles from outdoor facades. , 2010, Environmental pollution.

[5]  S. Klaine,et al.  Paradigms to assess the environmental impact of manufactured nanomaterials , 2012, Environmental toxicology and chemistry.

[6]  H. Mielke,et al.  Soil is an important pathway of human lead exposure. , 1998, Environmental health perspectives.

[7]  Anna M. Wise,et al.  Sulfidation of silver nanoparticles decreases Escherichia coli growth inhibition. , 2012, Environmental science & technology.

[8]  R. Scholz,et al.  Modeled environmental concentrations of engineered nanomaterials (TiO(2), ZnO, Ag, CNT, Fullerenes) for different regions. , 2009, Environmental science & technology.

[9]  Saioa Zorita,et al.  Aging of photocatalytic coatings under a water flow: Long run performance and TiO2 nanoparticles release , 2012 .

[10]  K Hungerbühler,et al.  Release of titanium dioxide from textiles during washing. , 2012, Environmental science & technology.

[11]  Albert A Koelmans,et al.  Analysis of engineered nanomaterials in complex matrices (environment and biota): General considerations and conceptual case studies , 2012, Environmental toxicology and chemistry.

[12]  Peter Wick,et al.  Is nanotechnology revolutionizing the paint and lacquer industry? A critical opinion. , 2013, The Science of the total environment.

[13]  M Boller,et al.  Synthetic TiO2 nanoparticle emission from exterior facades into the aquatic environment. , 2008, Environmental pollution.

[14]  Xiaohong Gu,et al.  Fate of nanoparticles during life cycle of polymer nanocomposites , 2011 .

[15]  M. Gaberšček,et al.  Photocatalytic activity of anatase-containing facade coatings , 2011 .

[16]  Damià Barceló,et al.  Analysis and assessment of the occurrence, the fate and the behavior of nanomaterials in the environment , 2011 .

[17]  Benjamin D. Stanford,et al.  Titanium distribution in swimming pool water is dominated by dissolved species. , 2013, Environmental pollution.

[18]  Elizabeth A. Casman,et al.  Decreasing uncertainties in assessing environmental exposure, risk, and ecological implications of nanomaterials. , 2009, Environmental science & technology.

[19]  Warren Friedman,et al.  The prevalence of lead-based paint hazards in U.S. housing. , 2002, Environmental health perspectives.

[20]  C. Neal,et al.  Titanium in UK rural, agricultural and urban/industrial rivers: geogenic and anthropogenic colloidal/sub-colloidal sources and the significance of within-river retention. , 2011, The Science of the total environment.

[21]  P. Westerhoff,et al.  Titanium dioxide nanoparticles in food and personal care products. , 2012, Environmental science & technology.

[22]  Keld Alstrup Jensen,et al.  Sanding dust from nanoparticle-containing paints: Physical characterisation , 2009 .

[23]  P. Christensen,et al.  Infrared spectroscopic evaluation of the photodegradation of paint Part I The UV degradation of acrylic films pigmented with titanium dioxide , 1999 .

[24]  Albert A Koelmans,et al.  Potential scenarios for nanomaterial release and subsequent alteration in the environment , 2012, Environmental toxicology and chemistry.

[25]  Jose R Peralta-Videa,et al.  Nanomaterials and the environment: a review for the biennium 2008-2010. , 2011, Journal of hazardous materials.

[26]  B. Nowack,et al.  Exposure modeling of engineered nanoparticles in the environment. , 2008, Environmental science & technology.

[27]  Fadri Gottschalk,et al.  The release of engineered nanomaterials to the environment. , 2011, Journal of environmental monitoring : JEM.

[28]  Nanna B. Hartmann,et al.  Ecotoxicity of engineered nanoparticles to aquatic invertebrates: a brief review and recommendations for future toxicity testing , 2008, Ecotoxicology.

[29]  Pedro J. J. Alvarez,et al.  Nanomaterials in the construction industry: a review of their applications and environmental health and safety considerations. , 2010, ACS nano.

[30]  L. Reijnders.  The release of TiO2 and SiO2 nanoparticles from nanocomposites , 2009 .