Process simulation of oxy-fuel combustion for a 300 MW pulverized coal-fired power plant using Aspen Plus

Abstract This work focuses on the amounts and components of flue gas for oxy-fuel combustion in a coal-fired power plant (CFPP). The combustion process of pulverized coal in a 300 MW power plant is studied using Aspen Plus software. The amount of each component in flue gas in coal-fired processes with air or O2/CO2 as oxidizer is obtained. The differences between the two processes are identified, and the influences of temperature, excess oxygen ratio and molar fraction of O2/CO2 on the proportions of different components in flue gas are examined by sensitivity analysis. The process simulation results show that replacing atmospheric air by a 21%O2/79%CO2 mixture leads the decrease of the flame temperature from 1789 °C to 1395 °C. The equilibrium amount of NOx declines obviously but the SOx are still at the same level. The mass fraction of CO2 in flue gas increased from 21.3% to 81.5%. The amount of NOx is affected sensitively by the change of temperature and the excess oxygen ratio, but the change of O2/CO2 molar fraction has a little influence to the generation of NOx. With the increasing of O2 concentration, the flame temperature and NOx emission enhance rapidly. When the molar fraction of O2 increases to 30%, the flame temperature is similar and the mass fraction of NOx is about 1/8 of that air atmosphere.

[1]  K. Okazaki,et al.  Effect of carbon dioxide on flame propagation of pulverized coal clouds in CO2/O2 combustion , 2007 .

[2]  Shengli Niu,et al.  Characteristic of coal combustion in oxygen/carbon dioxide atmosphere and nitric oxide release during this process , 2011 .

[3]  Ligang Zheng,et al.  Assessment of coal combustion in O2+CO2 by equilibrium calculations , 2003 .

[4]  Ken Okazaki,et al.  NOx reduction mechanism in coal combustion with recycled CO2 , 1997 .

[5]  Takashi Kiga,et al.  The characteristics of pulverized coal combustion in O2/CO2 mixtures for CO2 recovery , 1995 .

[6]  Alexander Mitsos,et al.  A review of recent developments in carbon capture utilizing oxy‐fuel combustion in conventional and ion transport membrane systems , 2011 .

[7]  G. F. Berry,et al.  Combustion of pulverized coal using waste carbon dioxide and oxygen , 1988 .

[8]  Eric Croiset,et al.  NOx and SO2 emissions from O2/CO2 recycle coal combustion , 2001 .

[9]  Yulong Ding,et al.  An integrated system for thermal power generation, electrical energy storage and CO2 capture , 2011 .

[10]  Noriyuki Kobayashi,et al.  CO2, NOx and SO2 emissions from the combustion of coal with high oxygen concentration gases , 2000 .

[11]  R. Payne,et al.  CO2 Recovery via Coal Combustion in Mixtures of Oxygen and Recycled Flue Gas , 1989 .

[12]  K. Arai,et al.  Trial design for a CO2 recovery power plant by burning pulverized coal in , 1997 .

[13]  Yaser Khojasteh Salkuyeh,et al.  Comparison of MEA and DGA performance for CO2 capture under different operational conditions , 2012 .

[14]  B. M. Gibbs,et al.  Comparisons of pulverized coal combustion in air and in mixtures of O2/CO2 , 2005 .

[15]  Sreenivas Jayanti,et al.  Flame structure and NO generation in oxy-fuel combustion at high pressures , 2009 .

[16]  RajenderKumar Gupta,et al.  Oxy-fuel combustion technology for coal-fired power generation , 2005 .

[17]  Pyong Sik Pak,et al.  Characteristic evaluation of a CO2-capturing repowering system based on oxy-fuel combustion and exergetic flow analyses for improving efficiency , 2010 .