Numerical investigation on the lifetime decline of burners in a wall-fired dual-fuel utility boiler

Abstract This paper reports the results of the numerical investigation on the causes of burners lifetime decline in a dual-fuel, front-wall-fired utility boiler. For this purpose, a three-dimensional modeling was performed using Computational Fluid Dynamics (CFD) to simulate a 150 MW boiler. The whole boiler, including the water-wall, low-NO x swirling burners with both types of nozzles, etc., was modeled in the real dimensions. Furthermore, the heat exchangers, like superheaters and economizers, were treated as porous media. Major attention was paid to the furnace zone, and especially region close to the burners where the failures have occasionally occurred due to the metal overheating. In order to achieve the objective, effects of the fuel type, the burners swirl ratio, droplet diameter of the fuel, and air-fuel ratio were investigated. Comparisons between numerical results, field measurements and plant observations showed the simulation can predict the flow and temperature fields in the boiler with acceptable accuracy for both fuels. It was found that, the most damage occurs while the plant works with natural gas, since the flame establishes closer to the burners. In this situation, the average heat flux received by the rear wall is about 0.25% higher than the received heat flux due to heavy fuel oil. Additionally, the rise in the swirl ratio of the burners can be another parameter, which strongly influences the flow and temperature field within the boiler and causes overheating damages to the burners and water-wall. Although variations in other investigated parameters have dramatic effects on performance characteristics of the boiler, they cannot lead to the overheating failure.

[1]  Masoud Rahimi,et al.  CFD modeling of a boiler’s tubes rupture , 2006 .

[2]  Norbert Modliński,et al.  Computational modeling of a utility boiler tangentially-fired furnace retrofitted with swirl burners , 2010 .

[3]  J. L. T. Azevedo,et al.  Combustion Characteristics of a Front-Wall-Fired Pulverized-Coal 300 MWe Utility Boiler , 1997 .

[4]  Peter Glarborg,et al.  Characterization of a full-scale, single-burner pulverized coal boiler: temperatures, gas concentrations and nitrogen oxides , 1994 .

[5]  B. Hjertager,et al.  On mathematical modeling of turbulent combustion with special emphasis on soot formation and combustion , 1977 .

[6]  Dong Yang,et al.  Experimental investigation on heat transfer and frictional characteristics of vertical upward rifled tube in supercritical CFB boiler , 2011 .

[7]  Peter M. Walsh,et al.  Unburned carbon loss from pulverized coal combustors , 1993 .

[8]  B. F. Magnussen,et al.  Numerical simulation of local extinction effects in turbulent combustor flows of methane and air , 1994 .

[9]  Iman Mirzaii,et al.  Simulation of Liquid Fuel Atomization in an Industrial Spray Nozzle of a Powerplant Boiler , 2010 .

[10]  Ho Young Park,et al.  Combustion and heat transfer characteristics of oxy-coal combustion in a 100 MWe front-wall-fired furnace , 2013 .

[11]  W. P. Jones,et al.  Global reaction schemes for hydrocarbon combustion , 1988 .

[12]  M. Kahrom,et al.  Numerical Investigation of the Effects of Fuel Injection Diameter on the Main Working Characteristics of a Power Plant Boiler , 2014 .

[13]  H. I. Abualhamayel,et al.  Influence of Inlet Conditions and Burner Tripping on NO and Temperature Characteristics in a Tangentially Fired Furnace , 2009 .

[14]  Lin Ma,et al.  Numerical modelling of the co-firing of pulverised coal and straw in a 300 MWe tangentially fired boiler , 2012 .

[15]  Huai-Chun Zhou,et al.  Experimental investigations on visualization of three-dimensional temperature distributions in a large-scale pulverized-coal-fired boiler furnace , 2005 .

[16]  Hari B. Vuthaluru,et al.  CFD based prediction of erosion rate in large scale wall-fired boiler , 2012 .

[17]  Hari B. Vuthaluru,et al.  Control of ash related problems in a large scale tangentially fired boiler using CFD modelling , 2010 .

[18]  Vladimir I. Kuprianov,et al.  Experimental study on effects of operating conditions and fuel quality on thermal efficiency and emission performance of a 300-MW boiler unit firing Thai lignite , 2007 .

[19]  Vedha Nayagam.  Pattern Formation in Diffusion Flames Embedded in von Kármán Swirling Flows , 2006 .

[20]  Honghi Tran,et al.  Numerical modeling of fine particle and deposit formation in a recovery boiler , 2014 .

[21]  Sze Zheng Yong,et al.  Oxy-fuel combustion of pulverized coal: Characterization, fundamentals, stabilization and CFD modeling , 2012 .

[22]  M. Pourkashanian,et al.  Combustion modelling opportunities and challenges for oxy-coal carbon capture technology , 2011 .

[23]  P. A. Tesner,et al.  Kinetics of dispersed carbon formation , 1971 .

[24]  Seyed Mostafa Hosseinalipour,et al.  Prediction of Droplet Size and Velocity Distribution in Droplet Formation Region of Liquid Spray , 2010, Entropy.

[25]  Roman Saveliev,et al.  Evaluation of performance of Anglo-Mafube bituminous South African coal in 550 MW opposite-wall and 575 MW tangential-fired utility boilers , 2014 .

[26]  Zhengqi Li,et al.  Review of gas/particle flow, coal combustion, and NOx emission characteristics within down-fired boilers , 2014 .

[27]  Eddy H. Chui,et al.  Performance improvement and reduction of emissions from coal-fired utility boilers in China , 2010 .

[28]  Behdad Moghtaderi,et al.  Computational modelling of a slag-reduction strategy in a wall-fired furnace , 1995 .

[29]  Hailong Li,et al.  Numerical investigation of heat transfer characteristics in utility boilers of oxy-coal combustion , 2014 .

[30]  Eddy H. Chui,et al.  Estimation of NOx emissions from coal-fired utility boilers , 2010 .

[31]  P. J. Stopford,et al.  Coupled fluid dynamics and whole plant simulation of coal combustion in a tangentially-fired boiler , 2010 .

[32]  Peter Glarborg,et al.  Influence of coal quality on combustion performance , 1998 .

[33]  A. K Raja,et al.  Power Plant Engineering , 2019 .

[34]  Juhun Song,et al.  Simulation studies on direct ash recycling and reburning technology in a tangentially fired 500 MW pulverized coal boiler , 2013 .

[35]  F. Antun,et al.  Lebanon , 1992, International psychiatry : bulletin of the Board of International Affairs of the Royal College of Psychiatrists.

[36]  Chung King Law,et al.  An augmented reduced mechanism for methane oxidation with comprehensive global parametric validation , 1998 .

[37]  Ho Young Park,et al.  Numerical and experimental investigations on the gas temperature deviation in a large scale, advanced low NOx, tangentially fired pulverized coal boiler , 2013 .