A surface-micromachined tunable microgyroscope

We present a surface-micromachined microgyroscope, whose resonant frequency is electrostatically-tunable after fabrication. The microgyroscope has two oscillation modes: a sensing mode and a actuating mode. In a theoretical study, the microgyroscope has been designed so that the resonant frequency in the sensing mode is higher than that in the actuating mode. A 4-mask surface-micromachining process for the tunable microgyroscope has been described, including the deep RIE of a 6 /spl mu/m-thick LPCVD polycrystalline silicon structure layer. In a experimental study, the resonant frequency in the sensing mode has been matched to that in actuating mode by applying an inter-plate bias voltage. Frequency matching for the fabricated microgyroscope has been achieved at 5.8 kHz under the bias voltage of 2 V in a reduced pressure of 0.1 torr. For an input angular rate of 50/spl deg//sec, an output signal of 20 mV has been measured from the tuned microgyroscope for an AC drive voltage of 2 V with a DC bias voltage of 3 V.

[1]  J. Bernstein,et al.  A micromachined comb-drive tuning fork rate gyroscope , 1993, [1993] Proceedings IEEE Micro Electro Mechanical Systems.

[2]  Katsuhiko Tanaka,et al.  A micromachined vibrating gyroscope , 1995, Proceedings IEEE Micro Electro Mechanical Systems. 1995.

[3]  Noel C. MacDonald,et al.  A micromachined, single-crystal silicon, tunable resonator , 1995 .

[4]  N. C. MacDonald,et al.  Capacitance Based Tunable Micromechanical Resonators , 1995, Proceedings of the International Solid-State Sensors and Actuators Conference - TRANSDUCERS '95.

[5]  N. C. MacDonald,et al.  Independent tuning of the linear and nonlinear stiffness coefficients of a micromechanical device , 1996, Proceedings of Ninth International Workshop on Micro Electromechanical Systems.