Experimental determination of highly dynamic forces during wood trunk comminution with a drum chipper

Using large wood chips for heating systems in industrial applications is becoming popular. As a result, the requirements of the machinery that produces these large wood chips have increased, especially on the chipping tools and on the surrounding supportive components. This paper evaluates the acting main forces on a chipping drum that produces large wood chips via field and laboratory-based experimental measurements. In this study, a variety of strain gauges are applied to selected areas of the rotating chipping drum to measure localised strain conditions during wood-stem cutting. Four different wood species were investigated for comparison. Furthermore, the influence of sharp and dull knives is analysed. With the aid of experimental measurements and analysis on a laboratory scale, linear models are developed to determine the chipping force, which is cutting depth-dependent, for a variety of wood species. Testing parameters for such models are proposed via load spectra. The variability of the acting force value is evident. The maximum load on the drum affects at 10% of the time of a single cut. The largest applied forces are between 1.6 and 1.8 higher than the calculated average force. The commuting hornbeam sample exhibits the highest resistance against chipping compared to the three-other species. Additionally, a change in the load is easily recognised in the field test when utilising dull chipping blades. A reconstruction of the alternate load direction is based on laboratory testing.

[1]  R. Spinelli,et al.  Wood chips size distribution in relation to blade wear and screen use , 2010 .

[2]  Anders Grönlund,et al.  MAIN AND NORMAL CUTTING FORCES BY MACHINING WOOD OF PINUS SYLVESTRIS , 2011 .

[3]  M. Gulliksson,et al.  A Laboratory Wood Chipper for Chipping Under Realistic Conditions , 2011 .

[4]  B. O. M. Axelsson,et al.  Studies of the main cutting force at and near a cutting edge , 2007, Holz als Roh- und Werkstoff.

[5]  Natascia Magagnotti,et al.  The effect of knife wear on chip quality and processing cost of chestnut and locust fuel wood , 2013 .

[6]  Michael den Herder,et al.  INFRES - Innovative and effective technology and logistics for forest residual biomass supply in the EU (311881) , 2015 .

[7]  L. Eliasson,et al.  Comparing the efficiency of drum and disc chippers , 2013 .

[8]  Stefan Seuring,et al.  Supply chain and logistics issues of bio-energy production. , 2011 .

[9]  Mats Ekevad,et al.  Main cutting force models for two species of tropical wood , 2012 .

[10]  L. Cristovão.  Machining properties of wood : Tool wear, cutting force and tensioning of blades , 2013 .

[11]  E. Kivimaa,et al.  Cutting force in woodworking. , 1950 .

[12]  Philippe Lorong,et al.  Simulation of green wood milling with discrete element method , 2015 .

[13]  G. Maier.  Spanungstechnische Grundlagen der Hackschnitzelerzeugung in Trommelhackern , 2007, Holz als Roh- und Werkstoff.

[14]  Raffaele Spinelli,et al.  Managing chipper knife wear to increase chip quality and reduce chipping cost , 2014 .