Effect of ambient temperature on electrical treeing characteristics in silicone rubber

In this paper, electrical treeing was investigated in room temperature vulcanized (RTV) silicone rubber (SiR) over a range of ambient temperatures. An ac voltage with a frequency of 50 Hz was applied between a needle-plate electrode to initiate the electrical tree at different ambient temperatures. Both the structures and the growth characteristics were observed by using a digital microscope system. Obtained results show that the tree initiates from a single branch with a white gap. Four typical tree structures, namely branch, bush, pine branch and bush-pine mixed tree, were observed within the sample. The occurrence of tree structures changes with the increase of ambient temperature, in which branch tree takes up a great proportion at 30°C while bush tree becomes dominated as the temperature rises up to 90°C. Meanwhile, the cumulative inception probability within the same time decreases obviously with the increase of ambient temperature. The growth rate of the tree is closely related to the ambient temperature. It is suggested that the increase of vulcanization network density and elastic modulus with ambient temperature may have great influence on the treeing characteristics (including growth rate, fractal dimension and treeing proportion).

[1]  B. Du,et al.  Recurrence plot analysis of discharge currents in tracking tests of gamma-ray irradiated polymers , 2008, IEEE Transactions on Dielectrics and Electrical Insulation.

[2]  B. Du,et al.  Phenomena and mechanism of electrical tree in silicone rubber , 2009, 2009 IEEE 9th International Conference on the Properties and Applications of Dielectric Materials.

[3]  Johan J. Smit,et al.  FAILURES OF MEDIUM VOLTAGE CABLE JOINTS IN RELATION TO THE AMBIENT TEMPERATURE , 2009 .

[4]  N. Shimizu,et al.  Electrical tree initiation , 1998 .

[5]  N. Shimizu,et al.  Effect of gas impregnation in silicone rubber on electrical tree initiation , 2007, 2007 Annual Report - Conference on Electrical Insulation and Dielectric Phenomena.

[6]  Y. Ogawa,et al.  First stage of 2-D electrical tree in silicone rubber , 2008, 2008 International Symposium on Electrical Insulating Materials (ISEIM 2008).

[7]  B. Du,et al.  Effects of low pressure on tracking failure of printed circuit boards , 2008, IEEE Transactions on Dielectrics and Electrical Insulation.

[8]  L. A. Kojovic,et al.  Prevention of underground cable splice failures , 2000, 2000 IEEE Industrial and Commercial Power Systems Technical Conference. Conference Record (Cat. No.00CH37053).

[9]  G. Chen,et al.  Electrical treeing characteristics in XLPE power cable insulation in frequency range between 20 and 500 Hz , 2009, IEEE Transactions on Dielectrics and Electrical Insulation.

[10]  A. Cavallini,et al.  PD inference for the early detection of electrical treeing in insulation systems , 2004, IEEE Transactions on Dielectrics and Electrical Insulation.

[11]  C. Mayoux,et al.  Analysis of the Propagation of Electrical Treeing Using Optical and Electrical Methods , 1980, IEEE Transactions on Electrical Insulation.

[12]  Yuanxiang Zhou,et al.  Effect of frequency on electrical tree characteristics in silicone rubber , 2009, 2009 IEEE 9th International Conference on the Properties and Applications of Dielectric Materials.

[13]  R. Densley,et al.  An Investigation into the Growth of Electrical Trees in XLPE Cable Insulation , 1979, IEEE Transactions on Electrical Insulation.

[14]  M. Yamaguchi,et al.  Development of 500-kV XLPE cables and accessories for long distance underground transmission lines-Part II: jointing techniques , 1994 .

[15]  T. Tanaka,et al.  Aging of polymeric and composite insulating materials. Aspects of interfacial performance in aging , 2002 .

[16]  L. Dissado,et al.  Predicting electrical breakdown in polymeric insulators. From deterministic mechanisms to failure statistics , 2002 .

[17]  L. Jiang.  Influence of Curvature Radius of Needle Tip on Characteristics of Electrical Treeing in Silicone Rubber , 2008 .

[18]  R. Bodega,et al.  On-site testing and PD diagnosis of high voltage power cables , 2008, IEEE Transactions on Dielectrics and Electrical Insulation.

[19]  K. Ando,et al.  Development of prefabricated joint for 275-kV XLPE cable , 1995 .

[20]  Len A. Dissado,et al.  Understanding electrical trees in solids: from experiment to theory , 2001, ICSD'01. Proceedings of the 20001 IEEE 7th International Conference on Solid Dielectrics (Cat. No.01CH37117).

[21]  M. Nawata,et al.  Electrical tree at high temperature in XLPE and effect of oxygen , 2000, 2000 Annual Report Conference on Electrical Insulation and Dielectric Phenomena (Cat. No.00CH37132).

[22]  N. Shimizu,et al.  Influence of Vacuum Evacuation on Electrical Tree Initiation in Silicone Rubber , 2006, 2006 IEEE Conference on Electrical Insulation and Dielectric Phenomena.

[23]  B. Stritzke.  Liquid Silicone Rubber , 2009 .

[24]  Leonard A. Dissado,et al.  Predicting electrical breakdown in polymeric insulators: from deterministic mechanisms to failure statistics , 2002, Annual Report Conference on Electrical Insulation and Dielectric Phenomena.

[25]  V. Englund,et al.  A versatile method to study electrical treeing in polymeric materials , 2009, IEEE Transactions on Dielectrics and Electrical Insulation.

[26]  M. Abou-Dakka,et al.  Luminescence and space charge in polymeric dielectrics - [whitehead memorial lecture (2008)] , 2009, IEEE Transactions on Dielectrics and Electrical Insulation.

[27]  Yu Li,et al.  Partial Discharge Pattern Characteristic of HV Cable Joints with Typical Artificial Defect , 2010, 2010 Asia-Pacific Power and Energy Engineering Conference.

[28]  Katsutoshi Kudo,et al.  Fractal analysis of electrical trees , 1998 .