Analysis of cyclic frosting and defrosting of a vehicle heat pump

[1]  J. Albrecht,et al.  Model for cyclic frosting and defrosting of flat tube heat exchangers: Theoretical analysis and experimental validation , 2023, Applied Thermal Engineering.

[2]  J. Albrecht,et al.  Flat tube heat exchangers: Experimental analysis of frosting and water retention , 2022, Applied Thermal Engineering.

[3]  Yiyu Chen,et al.  Experimental investigation on the heating performance of a CO2 heat pump system with intermediate cooling for electric vehicles , 2021 .

[4]  S. Ullrich,et al.  Numerical Study of the Airflow Distribution in a Passenger Car Cabin Validated with PIV , 2018, Notes on Numerical Fluid Mechanics and Multidisciplinary Design.

[5]  Binbin Yu,et al.  Heating performance evaluation of a CO2 heat pump system for an electrical vehicle at cold ambient temperatures , 2018, Applied Thermal Engineering.

[6]  Shuangfeng Wang,et al.  Gas-liquid two-phase flow distribution in parallel micro-channels with different header and channels' orientations , 2017 .

[7]  Fredrik Wallin,et al.  Simulation of Energy Used for Vehicle Interior Climate , 2015 .

[8]  G. Longo,et al.  A new model for refrigerant boiling inside Brazed Plate Heat Exchangers (BPHEs) , 2015 .

[9]  Claudio Zilio,et al.  A new computational procedure for refrigerant condensation inside herringbone-type Brazed Plate Heat Exchangers , 2015 .

[10]  René Rieberer,et al.  Parametric analysis of the defrosting process of a reversible heat pump system for electric vehicles , 2013 .

[11]  Kwan-Soo Lee,et al.  Frosting and defrosting characteristics of surface-treated louvered-fin heat exchangers: Effects of fin pitch and experimental conditions , 2013 .

[12]  Minglu Qu,et al.  An experimental investigation on reverse-cycle defrosting performance for an air source heat pump using an electronic expansion valve , 2012 .

[13]  Christian J.L. Hermes,et al.  In-situ study of frosting and defrosting processes in tube-fin evaporators of household refrigerating appliances , 2011 .

[14]  Yong Chan Kim,et al.  Heat transfer characteristics of accumulator heat exchangers under various geometric and operating conditions , 2011 .

[15]  P. Hrnjak,et al.  Heat rejection from R744 flow under uniform temperature cooling in a horizontal smooth tube around the critical point , 2011 .

[16]  Liang-Liang Shao,et al.  Comparison of heat pump performance using fin-and-tube and microchannel heat exchangers under frost conditions , 2010 .

[17]  Dong Huang,et al.  Comparison between hot-gas bypass defrosting and reverse-cycle defrosting methods on an air-to-water heat pump , 2009 .

[18]  Xian-min Guo,et al.  Experimental study on frost growth and dynamic performance of air source heat pump system , 2008 .

[19]  Wang Zhiyi,et al.  Defrost improvement by heat pump refrigerant charge compensating , 2008 .

[20]  Shiming Deng,et al.  A study on the performance of the airside heat exchanger under frosting in an air source heat pump water heater/chiller unit , 2004 .

[21]  Hakan Karatas,et al.  Frost formation on fin- and- tube heat exchangers. Part II—Experimental investigation of frost formation on fin- and- tube heat exchangers , 2004 .

[22]  Clark W. Bullard,et al.  Air-side thermal hydraulic performance of multi-louvered fin aluminum heat exchangers , 2002 .

[23]  A. Aroussi,et al.  PIV Measurement and Numerical Simulation of the Airflow Field in a Road Vehicle HVAC Splitter Duct , 2001 .

[24]  Shengming Liao,et al.  A correlation of optimal heat rejection pressures in transcritical carbon dioxide cycles , 2000 .

[25]  Chi-Chuan Wang,et al.  A generalized heat transfer correlation for Iouver fin geometry , 1997 .

[26]  M. Shah A general correlation for heat transfer during film condensation inside pipes , 1979 .

[27]  Prabhata K. Swamee,et al.  Explicit Equations for Pipe-Flow Problems , 1976 .

[28]  H. Martin A theoretical approach to predict the performance of chevron-type plate heat exchangers , 1996 .

[29]  Dennis L. O'Neal,et al.  Effect of short-tube orifice size on the performance of an air source heat pump during the reverse-cycle defrost , 1991 .

[30]  E. Kuwahara,et al.  Shortening the defrost time on a heat-pump air conditioner , 1986 .

[31]  V. Gnielinski New equations for heat and mass transfer in turbulent pipe and channel flow , 1976 .

[32]  F. Dittus,et al.  Heat transfer in automobile radiators of the tubular type , 1930 .