Whirling Modes Stability Criterion for a Magnetically Suspended Flywheel Rotor With Significant Gyroscopic Effects and Bending Modes

To intuitively analyze the absolute and relative stability of the forward and backward whirling modes of the high-speed magnetically suspended flywheel rotor with significant gyroscopic effects and bending modes, this paper presents a whirling modes stability criterion based on complex coefficient frequency characteristics method. Through variable reconstruction, the multiple-input multiple-output magnetically suspended rotor system is converted into a single-input single-output (SISO) system with complex coefficients. The stability equivalence of the systems before and after variable reconstruction has been proven. Based on this, the inherent relationships between the distribution of the closed-loop poles of the complex coefficient SISO system and the whirling modes stability are revealed, and the Nyquist stability criterion is further extended by applying the argument principle. All of these lay the foundation for the whirling modes stability theorem, and then, their stability criterion is further developed. Simulation and experimental results prove the effectiveness and correctness of the presented criterion.

[1]  Yuan Ren,et al.  Current-Sensing Resistor Design to Include Current Derivative in PWM H-Bridge Unipolar Switching Power Amplifiers for Magnetic Bearings , 2012, IEEE Transactions on Industrial Electronics.

[2]  Jiancheng Fang,et al.  Decoupling Control of Magnetically Suspended Rotor System in Control Moment Gyros Based on an Inverse System Method , 2012, IEEE/ASME Transactions on Mechatronics.

[3]  Markus Ahrens,et al.  Performance of a magnetically suspended flywheel energy storage device , 1996, IEEE Trans. Control. Syst. Technol..

[4]  Liu Kun,et al.  Modeling and low power control of active magnetic bearings system , 2011, Proceedings of 2011 International Conference on Modelling, Identification and Control.

[5]  Maarten Steinbuch,et al.  Optimal Control of a Mechanical Hybrid Powertrain , 2012, IEEE Transactions on Vehicular Technology.

[6]  Mason A. Peck,et al.  Reducing Base Reactions With Gyroscopic Actuation of Space-Robotic Systems , 2009, IEEE Transactions on Robotics.

[7]  Albert F. Kascak,et al.  Stabilizing Gyroscopic Modes in Magnetic-Bearing-Supported Flywheels by Using Cross-Axis Proportional Gains , 2013 .

[8]  Jiancheng Fang,et al.  AMB Vibration Control for Structural Resonance of Double-Gimbal Control Moment Gyro With High-Speed Magnetically Suspended Rotor , 2013, IEEE/ASME Transactions on Mechatronics.

[9]  Shyh-Leh Chen,et al.  Exact linearization of a voltage-controlled 3-pole active magnetic bearing system , 2002, IEEE Trans. Control. Syst. Technol..

[10]  Anna G. Stefanopoulou,et al.  Nonlinear control for magnetic levitation of automotive engine vales , 2006, IEEE Transactions on Control Systems Technology.

[11]  Yong-Chen Pei,et al.  Stability boundaries of a spinning rotor with parametrically excited gyroscopic system , 2009 .

[12]  Timothy P. Dever,et al.  Modeling and Development of a Magnetic Bearing Controller for a High Speed Flywheel System , 2004 .

[13]  Y. Xiao,et al.  Optimal control of the magnetic bearings for a flywheel energy storage system , 2009 .

[14]  G. S. Grewal,et al.  Inverse Nyquist array: a quantitative theory , 1995 .

[15]  Abd Alla El-Marhomy,et al.  Stability analysis of rotor-bearing systems via Routh-Hurwitz criterion , 2004 .

[16]  Yohji Okada,et al.  Cross-Feedback Stabilization of the Digitally Controlled Magnetic Bearing , 1992 .

[17]  Abd Alla El-Marhomy Effect of various rotor-bearing system parameters on the whirl stability of system rotational modes of motion , 1997 .

[18]  Kumar S. Ray,et al.  An extension of the characteristic sequences method to the case of repeated roots , 1984 .

[19]  Jinchen Ji,et al.  Dynamics of a Jeffcott rotor-magnetic bearing system with time delays , 2003 .

[20]  Francesco Sorge,et al.  Control of hysteretic instability in rotating machinery by elastic suspension systems subject to dry and viscous friction , 2010 .

[21]  Shao Zhang,et al.  A Novel Axial Flux Permanent-Magnet Machine for Flywheel Energy Storage System: Design and Analysis , 2011, IEEE Transactions on Industrial Electronics.

[22]  G. Schweitzer,et al.  Magnetic bearings : theory, design, and application to rotating machinery , 2009 .

[23]  R.H. Guess,et al.  Development of a hybrid flywheel/battery drive system for electric vehicle applications , 1977, IEEE Transactions on Vehicular Technology.

[24]  K. S. Yeung,et al.  Root-locus plot of systems with time delay , 1982 .

[25]  Gang Yang,et al.  Optimal Winding Arrangements of a Bearingless Switched Reluctance Motor , 2008, IEEE Transactions on Power Electronics.

[26]  Zengshi Chen PI and Sliding Mode Control of a Cuk Converter , 2012, IEEE Transactions on Power Electronics.

[27]  Albert F. Kascak,et al.  Stability Limits of a PD Controller for a Flywheel Supported on Rigid Rotor and Magnetic Bearings , 2013 .

[28]  Xiaofeng Zhang,et al.  Stability analysis of matrix converter with constant power loads and LC input filter , 2012, Proceedings of The 7th International Power Electronics and Motion Control Conference.

[29]  Fang Jiancheng Design of magnetically suspended elastic rotor notch filter based on two-frequency Bode diagram , 2008 .

[30]  Ayman S. Abdel-Khalik,et al.  Fault Current Contribution of Medium Voltage Inverter and Doubly-Fed Induction-Machine-Based Flywheel Energy Storage System , 2013, IEEE Transactions on Sustainable Energy.

[31]  Zongli Lin,et al.  Design, Construction and Modeling of a Flexible Rotor Active Magnetic Bearing Test Rig , 2010 .

[32]  Min-Chun Pan,et al.  Experimental study on the whip elimination of rotor-bearing systems with electromagnetic exciters , 2011 .

[33]  A. R. Oliva,et al.  High-Performance Control of a DC–DC Z-Source Converter Used for an Excitation Field Driver , 2012, IEEE Transactions on Power Electronics.

[34]  Behrooz Mashadi,et al.  Dual-Mode Power-Split Transmission for Hybrid Electric Vehicles , 2010, IEEE Transactions on Vehicular Technology.

[35]  Bruno Sareni,et al.  Sizing and Energy Management of a Hybrid Locomotive Based on Flywheel and Accumulators , 2009, IEEE Transactions on Vehicular Technology.

[36]  Jian Sun,et al.  Impedance-Based Stability Criterion for Grid-Connected Inverters , 2011, IEEE Transactions on Power Electronics.

[37]  Jongrae Kim,et al.  Evaluation of Stochastic Effects on Biomolecular Networks Using the Generalized Nyquist Stability Criterion , 2008, IEEE Transactions on Automatic Control.

[38]  Junjie Wei,et al.  A study of singularities for magnetic bearing systems with time delays , 2008 .

[39]  Yuan Ren,et al.  High-Precision Control for a Single-Gimbal Magnetically Suspended Control Moment Gyro Based on Inverse System Method , 2011, IEEE Transactions on Industrial Electronics.

[40]  Junming Zhang,et al.  Stability Criterion for Cascaded System With Constant Power Load , 2013, IEEE Transactions on Power Electronics.

[41]  Paolo Rocco,et al.  Modeling and experimental analysis of the vibrations in hard disk drives , 2002 .