Vision-based system identification technique for building structures using a motion capture system

Abstract This paper presents a new vision-based system identification (SI) technique for building structures by using a motion capture system (MCS). The MCS with outstanding capabilities for dynamic response measurements can provide gage-free measurements of vibrations through the convenient installation of multiple markers. In this technique, from the dynamic displacement responses measured by MCS, the dynamic characteristics (natural frequency, mode shape, and damping ratio) of building structures are extracted after the processes of converting the displacement from MCS to acceleration and conducting SI by frequency domain decomposition. A free vibration experiment on a three-story shear frame was conducted to validate the proposed technique. The SI results from the conventional accelerometer-based method were compared with those from the proposed technique and showed good agreement, which confirms the validity and applicability of the proposed vision-based SI technique for building structures. Furthermore, SI directly employing MCS measured displacements to FDD was performed and showed identical results to those of conventional SI method.

[1]  S. Guillaume,et al.  Measuring sub-mm structural displacements using QDaedalus: a digital clip-on measuring system developed for total stations , 2015 .

[2]  Ingo Neumann,et al.  The Benefit of 3D Laser Scanning Technology in the Generation and Calibration of FEM Models for Health Assessment of Concrete Structures , 2014, Sensors.

[3]  M. A. Sutton,et al.  Accurate measurement of three-dimensional deformations in deformable and rigid bodies using computer vision , 1993 .

[4]  Yukio Tamura,et al.  Full-scale structural monitoring using an integrated GPS and accelerometer system , 2006 .

[5]  Chris Bishop,et al.  Next-generation low-cost motion capture systems can provide comparable spatial accuracy to high-end systems. , 2013, Journal of applied biomechanics.

[6]  Qican Zhang,et al.  Dynamic 3-D shape measurement method: A review , 2010 .

[7]  Chung Bang Yun,et al.  Development and application of a vision-based displacement measurement system for structural health monitoring of civil structures , 2006 .

[8]  Piotr Olaszek,et al.  Investigation of the dynamic characteristic of bridge structures using a computer vision method , 1999 .

[9]  Jong-Jae Lee,et al.  A vision-based system for remote sensing of bridge displacement , 2006 .

[10]  Faouzi Ghrib,et al.  Damage Identification of Euler–Bernoulli Beams Using Static Responses , 2012 .

[11]  Ahsan Kareem,et al.  Tall Buildings and Damping: A Concept-Based Data-Driven Model , 2014 .

[12]  Xijun Ye,et al.  Modal identification of Canton Tower under uncertain environmental conditions , 2012 .

[13]  Siu-Kui Au,et al.  Fast Bayesian FFT Method for Ambient Modal Identification with Separated Modes , 2011 .

[14]  Siu-Kui Au,et al.  Bayesian operational modal analysis: Theory, computation, practice , 2013 .

[15]  Patrick Paultre,et al.  Modal identification based on continuous wavelet transform and ambient excitation tests , 2012 .

[16]  Masoud Sanayei,et al.  STRUCTURAL MODEL UPDATING USING EXPERIMENTAL STATIC MEASUREMENTS , 1997 .

[17]  Hong-Gyoo Sohn,et al.  Evaluation of Stiffness Changes in a High-Rise Building by Measurements of Lateral Displacements Using GPS Technology , 2013, Sensors.

[18]  Sébastien MousseauS. Mousseau,et al.  Assessment of the frequency domain decomposition technique by forced-vibration tests of a full-scale structure , 2008 .

[19]  Sami F. Masri,et al.  A vision-based approach for the direct measurement of displacements in vibrating systems , 2003 .

[20]  Hyo Seon Park,et al.  Analytical models for assessment of the safety of multi-span steel beams based on average strains from long gage optic sensors , 2007 .

[21]  Peng Zhang,et al.  Deformation monitoring of a super-tall structure using real-time strain data , 2014 .

[22]  Hyo Seon Park,et al.  Deformation Monitoring of a Building Structure Using a Motion Capture System , 2015, IEEE/ASME Transactions on Mechatronics.

[23]  Hyo Seon Park,et al.  A Deformed Shape Monitoring Model for Building Structures Based on a 2D Laser Scanner , 2013, Sensors.

[24]  Hyo Seon Park,et al.  Mathematical models for assessment of the safety of steel beams based on average strains from long gage optic sensors , 2006 .

[25]  Hyo Seon Park,et al.  An Integrative Structural Health Monitoring System for the Local/Global Responses of a Large-Scale Irregular Building under Construction , 2013, Sensors.

[26]  Guido Luzi,et al.  Comparison of seismometer and radar measurements for the modal identification of civil engineering structures , 2013 .

[27]  Reza Tarinejad,et al.  Modal identification of structures by a novel approach based on FDD-wavelet method , 2014 .

[28]  Lijun Wu,et al.  Dynamic testing of a laboratory model via vision-based sensing , 2014 .

[29]  Hua Yang,et al.  Dynamics-Based Stereo Visual Inspection Using Multidimensional Modal Analysis , 2013, IEEE Sensors Journal.

[30]  Hyo Seon Park,et al.  Measurement Model for the Maximum Strain in Beam Structures Using Multiplexed Fiber Bragg Grating Sensors , 2013, Int. J. Distributed Sens. Networks.

[31]  E. Şafak,et al.  Seismic Response of Transamerica Building. II: System Identification , 1991 .

[32]  Stathis C. Stiros,et al.  Measuring Deflections of a Short-Span Railway Bridge Using a Robotic Total Station , 2013 .

[33]  Hyo Seon Park,et al.  A New Position Measurement System Using a Motion-Capture Camera for Wind Tunnel Tests , 2013, Sensors.

[34]  Fanis Moschas,et al.  Measurement of the dynamic displacements and of the modal frequencies of a short-span pedestrian bridge using GPS and an accelerometer , 2011 .

[35]  Jung-Hoon Kim,et al.  3D displacement measurement model for health monitoring of structures using a motion capture system , 2015 .

[36]  J.P. Lynch,et al.  A Parallel Simulated Annealing Architecture for Model Updating in Wireless Sensor Networks , 2009, IEEE Sensors Journal.

[37]  Carmelo Gentile,et al.  A software tool for processing the displacement time series extracted from raw radar data , 2010 .

[38]  Yongchao Yang,et al.  Time-Frequency Blind Source Separation Using Independent Component Analysis for Output-Only Modal Identification of Highly Damped Structures , 2013 .

[39]  Tracy Kijewski-Correa,et al.  Full-Scale Verification of Dynamic Properties from Short Duration Records , 2007 .

[40]  Ahsan Kareem,et al.  Experimental Verification and Full-Scale Deployment of Global Positioning Systems to Monitor the Dynamic Response of Tall Buildings , 2006 .

[41]  Hyun Myung,et al.  Vision-based displacement measurement method for high-rise building structures using partitioning approach , 2010 .

[42]  Branko Glisic,et al.  Long-term monitoring of high-rise buildings connected by link bridges , 2014 .

[43]  Hyo Seon Park,et al.  Measurement of maximum strain of steel beam structures based on average strains from vibrating wire strain gages , 2013, Experimental Techniques.

[44]  Ivan Au Bayesian ambient modal identification: theory, computation and practice , 2013 .

[45]  Akihito Yoshida,et al.  Modal Identification of Structures by FDD and 2DOF-RD Technique , 2003 .

[46]  Jerome P. Lynch,et al.  Automated Modal Parameter Estimation by Parallel Processing within Wireless Monitoring Systems , 2008 .

[47]  Brenton Bailey Real Time 3D motion tracking for interactive computer simulations , 2007 .

[48]  Ronald Fedkiw,et al.  Automatic determination of facial muscle activations from sparse motion capture marker data , 2005, ACM Trans. Graph..

[49]  Hyo Seon Park,et al.  Application of GPS to monitoring of wind‐induced responses of high‐rise buildings , 2008 .

[50]  Chris Rizos,et al.  Advances in structural monitoring with Global Positioning System technology: 1997–2006 , 2007 .

[51]  Qifeng Yu,et al.  A universal and flexible theodolite-camera system for making accurate measurements over large volumes , 2012 .

[52]  Rune Brincker,et al.  Modal identification of output-only systems using frequency domain decomposition , 2001 .

[53]  Yi-Qing Ni,et al.  Theoretical and experimental modal analysis of the Guangzhou New TV Tower , 2011 .

[54]  KwangYun Wohn,et al.  Sensor fusion for motion capture system based on system identification , 2000, Proceedings Computer Animation 2000.

[55]  Hyo Seon Park,et al.  Field Monitoring of Column Shortenings in a High-Rise Building during Construction , 2013, Sensors.

[56]  M. Becker,et al.  Monitoring of displacements with ground-based microwave interferometry: IBIS-S and IBIS-L , 2010 .

[57]  Filipe Magalhães,et al.  Damping Estimation Using Free Decays and Ambient Vibration Tests , 2010 .

[58]  Claus-Peter Fritzen,et al.  Operational modal analysis for Canton Tower , 2012 .