A 2G/3G/4G SAW-Less Receiver Front-End Adopting Switchable Front-End Architecture

In this paper, a surface acoustic wave (SAW)-less receiver (RX) front-end adopting switchable front-end architecture has been presented for second-generation/third-generation/fourth-generation cellular applications. Depending on the RX-transmitter (TX) frequency separation, a favorable down-mixing architecture is selected between a current-sampling mixer and a voltage-sampling mixer. The proposed switchable architecture meets the specification of an input-referred second-order intercept point (IIP2) for the SAW-less RX while minimizing the power consumption. The implemented RX front-end consists of a wideband capacitor cross-coupled common-gate low-noise amplifier, a 25% duty-cycle passive mixer with IIP2 calibration circuitry, a baseband transconductor, and a trans-impedance amplifier. Fabricated in a 65-nm CMOS process, the SAW-less RX front-end provides conversion gain of 42 dB, and achieves noise figure of below 3.3 dB, out-of-band input-referred third-order intercept point of -2 dBm, and IIP2 of more than 56 dBm. It draws an average current of 14.8 mA from 1.2 V. The die area is 1.71 mm2.

[1]  Caroline Andrews,et al.  A passive-mixer-first receiver with baseband-controlled RF impedance matching, ≪ 6dB NF, and ≫ 27dBm wideband IIP3 , 2010, 2010 IEEE International Solid-State Circuits Conference - (ISSCC).

[2]  Vladimir Aparin,et al.  A Resistively Degenerated Wideband Passive Mixer With Low Noise Figure and High ${\rm IIP}_{2}$ , 2010, IEEE Transactions on Microwave Theory and Techniques.

[3]  Eric A. M. Klumperink,et al.  A 0.2-to-2.0GHz 65nm CMOS receiver without LNA achieving ≫11dBm IIP3 and ≪6.5 dB NF , 2009, 2009 IEEE International Solid-State Circuits Conference - Digest of Technical Papers.

[4]  Jun Deguchi,et al.  A Fully Integrated 2 $\times$ 1 Dual-Band Direct-Conversion Mobile WiMAX Transceiver With Dual-Mode Fractional Divider and Noise-Shaping Transimpedance Amplifier in 65 nm CMOS , 2010, IEEE Journal of Solid-State Circuits.

[5]  Lu Han,et al.  A Single–Chip 10-Band WCDMA/HSDPA 4-Band GSM/EDGE SAW-less CMOS Receiver With DigRF 3G Interface and ${+}$90 dBm IIP2 , 2009, IEEE Journal of Solid-State Circuits.

[6]  Xin He,et al.  A compact SAW-less multiband WCDMA/GPS receiver front-end with translational loop for input matching , 2011, 2011 IEEE International Solid-State Circuits Conference.

[7]  Pietro Andreani,et al.  A 9-band WCDMA/EDGE transceiver supporting HSPA evolution , 2011, 2011 IEEE International Solid-State Circuits Conference.

[8]  Jonathan Borremans,et al.  A 40 nm CMOS 0.4–6 GHz Receiver Resilient to Out-of-Band Blockers , 2011, IEEE Journal of Solid-State Circuits.

[9]  Ralf Wunderlich,et al.  An Active Feedback Interference Cancellation Technique for Blocker Filtering in RF Receiver Front-Ends , 2010, IEEE Journal of Solid-State Circuits.

[10]  Jon Strange,et al.  A receiver for WCDMA/EDGE mobile phones with inductorless front-end in 65nm CMOS , 2011, 2011 IEEE International Solid-State Circuits Conference.

[11]  Ahmad Mirzaei,et al.  A Blocker-Tolerant, Noise-Cancelling Receiver Suitable for Wideband Wireless Applications , 2012, IEEE Journal of Solid-State Circuits.

[12]  Khurram Muhammad,et al.  IIP2 Calibration by Injecting DC Offset at the Mixer in a Wireless Receiver , 2007, IEEE Transactions on Circuits and Systems II: Express Briefs.

[13]  David J. Allstot,et al.  A capacitor cross-coupled common-gate low-noise amplifier , 2005, IEEE Transactions on Circuits and Systems II: Express Briefs.

[14]  O. Oliaei,et al.  Single-Chip Multiband EGPRS and SAW-Less LTE WCDMA CMOS Receiver With Diversity , 2012, IEEE Transactions on Microwave Theory and Techniques.

[15]  N. Weste,et al.  A 500 MHz CMOS anti-alias filter using feed-forward op-amps with local common-mode feedback , 2003 .

[16]  Sankaran Aniruddhan,et al.  A 65nm CMOS SoC with embedded HSDPA/EDGE transceiver, digital baseband and multimedia processor , 2011, 2011 IEEE International Solid-State Circuits Conference.

[17]  H. Darabi,et al.  A Blocker Filtering Technique for SAW-Less Wireless Receivers , 2007, IEEE Journal of Solid-State Circuits.