Investigation into the Vibrational Responses of Cylinder Liners in an IC Engine Fueled with Biodiesel

The paper presents a study of the relationship between the combustion behavior and vibration response of internal combustion (IC) engines fueled with biodiesel based on finite element modelling along with experimental evaluation. An improved finite element (FE) model is established and validated to predict the dynamic responses of cylinder liners with respect to two main sources: combustion shock and piston side thrust. Based on the validated FE model, the response characteristics of the cylinder liner in an IC engine fueled with biodiesel and its causal relationship with excitation sources have been predicted. Due to the lower calorific value of biodiesel, a greater amount of fuel is injected into the combustion chamber to maintain power outputs, which results in a prolonged combustion duration and subsequent higher overall vibration levels, compared with that of diesel. The advanced ignition of biodiesel is the main cause to the compound effect on the coupling of piston side-thrust force, thereby resulting in a nonlinear increase in the root mean square (RMS) of local vibration response close to the combustion top dead center (TDC). These key findings provides insight understandings for not only biodiesel combustion diagnostics but also more accurate diagnostics of fossil diesel based on nonintrusive vibrations.

[1]  José Luis Míguez,et al.  Performance and exhaust emissions in the use of biodiesel in outboard diesel engines , 2007 .

[2]  L. L. Ting,et al.  Piston Ring Lubrication and Cylinder Bore Wear Analyses, Part II—Theory Verification , 1974 .

[3]  Jean-Louis Lacoume,et al.  Separation of combustion noise and piston-slap in diesel engine—Part II: Separation of combustion noise and piston-slap using blind source separation methods , 2005 .

[4]  S.M.R. Khalili,et al.  Transient dynamic response of composite circular cylindrical shells under radial impulse load and axial compressive loads , 2005 .

[5]  Jian Chen,et al.  Investigation into piston-slap-induced vibration for engine condition simulation and monitoring , 2005 .

[6]  Ghassan Tashtoush,et al.  Combustion performance and emissions of ethyl ester of a waste vegetable oil in a water-cooled furnace , 2003 .

[7]  H. Aydin,et al.  Performance and emission analysis of cottonseed oil methyl ester in a diesel engine. , 2010 .

[8]  Avinash Kumar Agarwal,et al.  Biofuels (alcohols and biodiesel) applications as fuels for internal combustion engines , 2007 .

[9]  Mohsen Azadbakht,et al.  Characterization of engine's combustion-vibration using diesel and biodiesel fuel blends by time-frequency methods: A case study , 2016 .

[10]  Gequn Shu,et al.  Calculation on cylinder pressure fluctuation by using the wave equation in KIVA program , 2012 .

[11]  F. Guillet,et al.  Separation of combustion noise and piston-slap in diesel engine—Part I: Separation of combustion noise and piston-slap in diesel engine by cyclic Wiener filtering , 2005 .

[12]  Naoto Ono,et al.  New Three-dimensional Piston Secondary Motion Analysis Method Coupling Structure Analysis and Multi Body Dynamics Analysis , 2011 .

[13]  Kadir Aydin,et al.  Experimental and regression analysis of noise and vibration of a compression ignition engine fuelled with various biodiesels , 2016 .

[14]  Malcolm J. Crocker,et al.  Vibration analysis of long cylindrical shells using acoustical excitation , 2011 .

[15]  Stephanos Theodossiades,et al.  On the identification of piston slap events in internal combustion engines using tribodynamic analysis , 2015 .

[16]  Sam Ki Yoon,et al.  Application of Canola Oil Biodiesel/Diesel Blends in a Common Rail Diesel Engine , 2016 .

[17]  K. A. Subramanian,et al.  Alternative fuels for transportation vehicles: A technical review , 2013 .

[18]  J. R. Cho,et al.  A numerical analysis of the interaction between the piston oil film and the component deformation in a reciprocating compressor , 2005 .