Simulation of 3 Phase to 3 Phase Power Conversion Using Matrix Converter with Maximum and Minimum Voltage Transfer Ratio

This paper proposes a new approach of design and implementation of 3 phase to 3 phase conversion using matrix converter. It includes the design, modeling and implementation. The entire matrix converter circuits are developed by mathematical model so as to reduce computational time and performances of the converter are evaluated using MATLAB/SIMULINK for RL Load. The mathematical expressions relating the input and output of the three phase matrix converter are implemented by using simulink block set. The duty cycles of the matrix converter bidirectional switches are calculated using modified venturini algorithm for maximum (0.866) and minimum (0.5) voltage transfer ratio.

[1]  A. Alesina,et al.  Analysis and design of optimum-amplitude nine-switch direct AC-AC converters , 1989 .

[2]  A. Zuckerberger,et al.  Simulation of three-phase loaded matrix converter , 1996 .

[3]  Ahmet M. Hava,et al.  The matrix converter drive performance under abnormal input voltage conditions , 2001, 2001 IEEE 32nd Annual Power Electronics Specialists Conference (IEEE Cat. No.01CH37230).

[4]  José R. Rodríguez,et al.  Matrix converters: a technology review , 2002, IEEE Trans. Ind. Electron..

[5]  Jon C. Clare,et al.  Gate drive level intelligence and current sensing for matrix converter current commutation , 2002, IEEE Trans. Ind. Electron..

[6]  U. Ammann,et al.  Predictive Approach to Increase Efficiency and Reduce Switching Losses on Matrix Converters , 2009, IEEE Transactions on Power Electronics.

[7]  J.-I. Itoh,et al.  A New Bidirectional Switch With Regenerative Snubber to Realize a Simple Series Connection for Matrix Converters , 2009, IEEE Transactions on Power Electronics.

[8]  A. Lindemann,et al.  Bidirectional Switch Commutation for a Matrix Converter Supplying a Series Resonant Load , 2009, IEEE Transactions on Power Electronics.

[9]  Peng Wang,et al.  Digital Carrier Modulation and Sampling Issues of , 2009 .

[10]  Sangshin Kwak,et al.  Fault-Tolerant Structure and Modulation Strategies With Fault Detection Method for Matrix Converters , 2010, IEEE Transactions on Power Electronics.

[11]  Patrick Wheeler,et al.  Predictive Torque Control of an Induction Machine Fed by a Matrix Converter With Reactive Input Power Control , 2010, IEEE Transactions on Power Electronics.

[12]  Minh-Khai Nguyen,et al.  A Single-Phase Z-Source Buck–Boost Matrix Converter , 2010, IEEE Transactions on Power Electronics.

[13]  Richard W G Bucknall,et al.  On the Conceptual Design and Performance of a Matrix Converter for Marine Electric Propulsion , 2010, IEEE Transactions on Power Electronics.