Transport Phenomena Analysis in Proton Exchange Membrane Fuel Cells

The objective of this review is to provide a summary of modeling and experimental research efforts on transport phenomena in proton exchange membrane fuel cells (PEMFCs). Several representative PEMFC models and experimental studies in macro and micro PEMFCs are selected for discussion. No attempt is made to examine all the models or experimental studies, but rather the focus is to elucidate the macro-homogeneous modeling methodologies and representative experimental results. Since the transport phenomena are different in different regions of a fuel cell, fundamental phenomena in each region are first reviewed. This is followed by the presentation of various theoretical models on these transport processes in PEMFCs. Finally, experimental investigation on the cell performance of macro and micro PEMFC and DMFC is briefly presented.

[1]  G. Dagan Flow and transport in porous formations , 1989 .

[2]  Dawn Bernardi,et al.  Water‐Balance Calculations for Solid‐Polymer‐Electrolyte Fuel Cells , 1990 .

[3]  Mark W. Verbrugge,et al.  Ion and Solvent Transport in Ion‐Exchange Membranes I . A Macrohomogeneous Mathematical Model , 1990 .

[4]  Mark W. Verbrugge,et al.  Analysis of Promising Perfluorosulfonic Acid Membranes for Fuel‐Cell Electrolytes , 1990 .

[5]  M. Verbrugge,et al.  Mathematical model of a gas diffusion electrode bonded to a polymer electrolyte , 1991 .

[6]  T. Springer,et al.  Polymer Electrolyte Fuel Cell Model , 1991 .

[7]  A. Parthasarathy,et al.  Pressure Dependence of the Oxygen Reduction Reaction at the Platinum Microelectrode/Nafion Interface: Electrode Kinetics and Mass Transport , 1992 .

[8]  R. Carbonell,et al.  Interpretation of transport coefficients in Nafion using a parallel pore model , 1992 .

[9]  Mark W. Verbrugge,et al.  A Mathematical Model of the Solid‐Polymer‐Electrolyte Fuel Cell , 1992 .

[10]  T. Fuller,et al.  Water and Thermal Management in Solid‐Polymer‐Electrolyte Fuel Cells , 1993 .

[11]  T. Springer,et al.  Water Uptake by and Transport Through Nafion® 117 Membranes , 1993 .

[12]  T. Springer,et al.  Modeling and Experimental Diagnostics in Polymer Electrolyte Fuel Cells , 1993 .

[13]  Ralph E. White,et al.  A water and heat management model for proton-exchange-membrane fuel cells , 1993 .

[14]  Yong Woo Rho,et al.  Mass Transport Phenomena in Proton Exchange Membrane Fuel Cells Using O 2 / He , O 2 / Ar , and O 2 / N 2 Mixtures I . Experimental Analysis , 1994 .

[15]  J. C. Amphlett,et al.  Performance modeling of the Ballard Mark IV solid polymer electrolyte fuel cell. II: Empirical model development , 1995 .

[16]  Trung Van Nguyen,et al.  A Gas Distributor Design for Proton‐Exchange‐Membrane Fuel Cells , 1996 .

[17]  Chao-Yang Wang,et al.  A multiphase mixture model for multiphase, multicomponent transport in capillary porous media—I. Model development , 1996 .

[18]  S. Srinivasan,et al.  Measurements of proton conductivity in the active layer of PEM fuel cell gas diffusion electrodes , 1998 .

[19]  Angelika Heinzel,et al.  Membrane fuel cells : concepts and system design , 1998 .

[20]  E. Michaelides,et al.  Transport processes of water and protons through micropores , 1998 .

[21]  Sadik Kakac,et al.  Two‐dimensional model for proton exchange membrane fuel cells , 1998 .

[22]  T. Nguyen,et al.  An Along‐the‐Channel Model for Proton Exchange Membrane Fuel Cells , 1998 .

[23]  Hongtan Liu,et al.  Modelling of performance of PEM fuel cells with conventional and interdigitated flow fields , 1999 .

[24]  William H. Smyrl,et al.  A Miniature Methanol/Air Polymer Electrolyte Fuel Cell , 1999 .

[25]  T. Nguyen,et al.  Multicomponent transport in porous electrodes of proton exchange membrane fuel cells using the interdigitated gas distributors , 1999 .

[26]  Ned Djilali,et al.  A two-dimensional analysis of mass transport in proton exchange membrane fuel cells , 1999 .

[27]  A. A. Kulikovsky,et al.  Modeling the Cathode Compartment of Polymer Electrolyte Fuel Cells: Dead and Active Reaction Zones , 1999 .

[28]  3-D Model of Proton Exchange Membrane Fuel Cells , 2000, Heat Transfer: Volume 1.

[29]  Zuomin Dong,et al.  DESIGN OPTIMIZATION OF A COMPLEX MECHANICAL SYSTEM USING ADAPTIVE RESPONSE SURFACE METHOD , 2000 .

[30]  Z. H. Wang,et al.  Two-phase flow and transport in the air cathode of proton exchange membrane fuel cells , 2000 .

[31]  Chao-Yang Wang,et al.  Computational Fluid Dynamics Modeling of Proton Exchange Membrane Fuel Cells , 2000 .

[32]  A. Shukla,et al.  Diffusion layer parameters influencing optimal fuel cell performance , 2000 .

[33]  James Larminie,et al.  Fuel Cell Systems Explained , 2000 .

[34]  S. Dutta,et al.  Three-dimensional numerical simulation of straight channel PEM fuel cells , 2000 .

[35]  S. Dutta,et al.  NUMERICAL PREDICTION OF TEMPERATURE DISTRIBUTION IN PEM FUEL CELLS , 2000 .

[36]  Frano Barbir,et al.  An Analytical Solution of a Half‐Cell Model for PEM Fuel Cells , 2000 .

[37]  T. Nguyen,et al.  Two-phase flow model of the cathode of PEM fuel cells using interdigitated flow fields , 2000 .

[38]  Trung Van Nguyen,et al.  A Two-Dimensional, Two-Phase, Multicomponent, Transient Model for the Cathode of a Proton Exchange Membrane Fuel Cell Using Conventional Gas Distributors , 2001 .

[39]  K. S. Dhathathreyan,et al.  Humidification studies on polymer electrolyte membrane fuel cell , 2001 .

[40]  S. Dutta,et al.  Numerical prediction of mass-exchange between cathode and anode channels in a PEM fuel cell , 2001 .

[41]  A. Kornyshev,et al.  Proton transfer in a single pore of a polymer electrolyte membrane , 2001 .

[42]  Ned Djilali,et al.  THREE-DIMENSIONAL COMPUTATIONAL ANALYSIS OF TRANSPORT PHENOMENA IN A PEM FUEL CELL , 2002 .

[43]  Hongtan Liu,et al.  A two-phase flow and transport model for the cathode of PEM fuel cells , 2002 .

[44]  Hongtan Liu,et al.  Heat transfer enhancement in fuel cells with interdigitated flow field design , 2002 .

[45]  W. L. Worrell,et al.  Development of solid oxide fuel cells for the direct oxidation of hydrocarbon fuels , 2002 .

[46]  Suk Won Cha,et al.  Design and fabrication of a micro fuel cell array with “flip-flop” interconnection , 2002 .

[47]  Jeremy P. Meyers,et al.  Design considerations for miniaturized PEM fuel cells , 2002 .

[48]  Fabrication of Miniature Silicon Wafer Fuel Cells Using Micro Fabrication Technologies , 2003 .

[49]  Jin Hyun Nam,et al.  Effective diffusivity and water-saturation distribution in single- and two-layer PEMFC diffusion medium , 2003 .

[50]  Performance modeling of PEM fuel cell operated on reformate , 2003 .

[51]  Jingrong Yu,et al.  Fabrication of miniature silicon wafer fuel cells with improved performance , 2003 .

[52]  Xiang Zhang,et al.  A micro methanol fuel cell operating at near room temperature , 2003 .

[53]  Suk Won Cha,et al.  Investigation of Transport Phenomena in Micro Flow Channels for Miniature Fuel Cells , 2003 .

[54]  P. Cheng,et al.  Fabrication of a miniature twin-fuel-cell on silicon wafer , 2003 .

[55]  James Larminie,et al.  Fuel Cell Systems Explained: Larminie/Fuel Cell Systems Explained , 2003 .

[56]  Lin Wang,et al.  A parametric study of PEM fuel cell performances , 2003 .

[57]  Hongtan Liu,et al.  A 3D model for PEM fuel cells operated on reformate , 2004 .

[58]  Chao-Yang Wang,et al.  Electron Transport in PEFCs , 2004 .

[59]  A. Weber,et al.  Modeling transport in polymer-electrolyte fuel cells. , 2004, Chemical reviews.

[60]  S. Patankar Numerical Heat Transfer and Fluid Flow , 2018, Lecture Notes in Mechanical Engineering.