Simulation of energy saving potential of a centralized HVAC system in an academic building using adaptive cooling technique

Abstract Application of adaptive comfort temperature as room temperature set points potentially reduce energy usage of the HVAC system during a cooling and heating period. The savings are mainly due to higher indoor temperature set point during hot period and lower indoor temperature set point during cold period than the recommended value. Numerous works have been carried out to show how much energy can be saved during cooling and heating period by applying adaptive comfort temperature. The previous work, however, focused on a continuous cooling load as found in many office and residential buildings. Therefore, this paper aims to simulate the energy saving potential for an academic glazed building in tropical Malaysian climate by developing adaptive cooling technique. A building simulation program (TRNSYS) was used to model the building and simulate the cooling load characteristic using current and proposed technique. Two experimental measurements were conducted and the results were used to validate the model. Finally, cooling load characteristic of the academic building using current and proposed technique were compared and the results showed that annual energy saving potential as much as 305,150 kW h can be achieved.

[1]  Ivan Korolija,et al.  Influence of building parameters and HVAC systems coupling on building energy performance , 2011 .

[2]  Zheng Li,et al.  The characteristics of space cooling load and indoor humidity control for residences in the subtropics , 2006 .

[3]  Ibrahim Hussein,et al.  Field study on thermal comfort in Malaysia , 2009 .

[4]  Michael A. Humphreys,et al.  ADAPTIVE THERMAL COMFORT AND SUSTAINABLE THERMAL STANDARDS FOR BUILDINGS , 2002 .

[5]  Kostas Laskos,et al.  Assessing cooling energy performance of windows for residential buildings in the Mediterranean zone , 2012 .

[6]  Y. Çengel,et al.  Thermodynamics : An Engineering Approach , 1989 .

[7]  Yalçın Yaşar,et al.  The effects of window alternatives on energy efficiency and building economy in high-rise residential buildings in moderate to humid climates , 2012 .

[8]  Madhavi Indraganti,et al.  Using the adaptive model of thermal comfort for obtaining indoor neutral temperature: Findings from a field study in Hyderabad, India , 2010 .

[9]  Eric Wai Ming Lee,et al.  A study of the importance of occupancy to building cooling load in prediction by intelligent approach , 2011 .

[10]  Gail Brager,et al.  Thermal comfort in naturally ventilated buildings: revisions to ASHRAE Standard 55 , 2002 .

[11]  J. E. Janssen,et al.  Ventilation for acceptable indoor air quality , 1989 .

[12]  James A. Davis,et al.  Occupancy diversity factors for common university building types , 2010 .

[13]  Greg Schoenau,et al.  Investigation of some large building energy conservation opportunities using the doe-2 model , 1999 .

[14]  Liu Yang,et al.  Building energy efficiency in different climates , 2008 .

[15]  Baizhan Li,et al.  Occupants' adaptive responses and perception of thermal environment in naturally conditioned university classrooms , 2010 .

[16]  J. C. Lam,et al.  An analysis of daylighting and solar heat for cooling-dominated office buildings , 1999 .

[17]  Gail Brager,et al.  The adaptive model of thermal comfort and energy conservation in the built environment. , 2001 .

[18]  K. W. Mui,et al.  Adaptive comfort temperature model of air-conditioned building in Hong Kong , 2003 .

[19]  Kamaruzzaman Sopian,et al.  Thermal comfort in naturally ventilated office under varied opening arrangements: Objective and subjective approach , 2009 .

[20]  Athanasios Tzempelikos,et al.  Indoor thermal environmental conditions near glazed facades with shading devices - Part II: Thermal comfort simulation and impact of glazing and shading properties , 2010 .

[21]  Jlm Jan Hensen,et al.  Overview of HVAC system simulation , 2010 .

[22]  A. Stegou-Sagia,et al.  The impact of glazing on energy consumption and comfort , 2007 .

[23]  Jeffrey D. Spitler,et al.  The Radiant Time Series Cooling Load Calculation Procedure , 1997 .

[24]  Ibrahim Hussein,et al.  Field studies on thermal comfort of air-conditioned and non air-conditioned buildings in Malaysia , 2009, 2009 3rd International Conference on Energy and Environment (ICEE).

[25]  Reinhard Radermacher,et al.  Simulation of a VAV air conditioning system in an existing building for the cooling mode , 2009 .

[26]  K. W. Mui,et al.  Cooling load calculations in subtropical climate , 2007 .

[27]  J. F. Nicol,et al.  Developing an adaptive control algorithm for Europe , 2002 .

[28]  F. Nicol.  Adaptive thermal comfort standards in the hot–humid tropics , 2004 .

[29]  Shan K. Wang,et al.  Handbook of Air Conditioning and Refrigeration , 1993 .