Ormosil coating-based oxygen sensor for aircraft ullage

Significant emphasis has been placed on fuel tank safety since the TWA flight 800 accident in July 1996. Upon investigation the National Transportation Safety Board (NTSB) determined that the probable cause of the accident was an explosion of the center wing tank (CWT), resulting from ignition of the flammable fuel/air mixture in the tank. The Federal Aviation Administration (FAA) has focused research to support two primary methods of fuel tank protection -- ground-based and on-board -- both involving fuel tank inerting. Ground-based fuel tank inerting involves some combination of fuel scrubbing and ullage washing with Nitrogen Enriched Air (NEA) while the airplane is on the ground (applicable to all or most operating transport airplanes). On-board fuel tank inerting involves ullage washing with OBIGGS (on-board inert gas generating system), a system that generates NEA during aircraft operations. An OBIGGS generally encompasses an air separation module (ASM) to generate NEA, a compressor, storage tanks, and a distribution system. Essential to the utilization of OBIGGS is an oxygen sensor that can operate inside the aircraft's ullage and assess the effectiveness of the inerting systems. OBIGGS can function economically by precisely knowing when to start and when to stop. Toward achieving these goals, InnoSense LLC is developing an all-optical fuel tank ullage sensor (FTUS) prototype for detecting oxygen in the ullage of an aircraft fuel tank in flight conditions. Data would be presented to show response time and wide dynamic range of the sensor in simulated flight conditions and fuel tank environment.

[1]  B. MacCraith,et al.  Tailoring of sol-gel films for optical sensing of oxygen in gas and aqueous phase. , 1998, Analytical chemistry.

[2]  O. Wolfbeis,et al.  Oxygen optrode for use in a fiber-optic glucose biosensor. , 1990, Analytical chemistry.

[3]  Sonja Draxler,et al.  Luminescence decay-time-based optical sensors: principles and problems , 1993 .

[4]  A. Vengsarkar,et al.  Optical fiber long-period grating sensors. , 1996, Optics letters.

[5]  I Gryczynski,et al.  Background suppression in frequency-domain fluorometry. , 2000, Analytical biochemistry.

[6]  B. MacCraith,et al.  Optical Sol-Gel-Based Dissolved Oxygen Sensor: Progress Towards a Commercial Instrument , 1998 .

[7]  Colette McDonagh,et al.  Phase fluorometric dissolved oxygen sensor , 2001 .

[8]  A Liljeborg,et al.  Characterization of probe binding and comparison of its influence on fluorescence lifetime of two pH-sensitive benzo[c]xanthene dyes using intensity-modulated multiple-wavelength scanning technique. , 2000, Analytical biochemistry.

[9]  Xavier Daxhelet,et al.  Theory and practice of long-period gratings: when a loss becomes a gain. , 2003, Optics letters.

[10]  Gia-Wei Chern,et al.  Analysis of cladding-mode couplings for a lensed fiber integrated with a long-period fiber grating by use of the beam-propagation method. , 2002, Applied optics.

[11]  I Klimant,et al.  Sol-gel based glucose biosensors employing optical oxygen transducers, and a method for compensating for variable oxygen background. , 2000, Biosensors & bioelectronics.

[12]  I Gryczynski,et al.  Low-frequency modulation sensors using nanosecond fluorophores. , 1998, Analytical chemistry.

[13]  Michael J. O'Brien,et al.  Phase-sensitive multichannel detection system for chemical and biosensor arrays and fluorescence lifetime-based imaging , 2000 .