Sugarcane bagasse reinforced phenolic and lignophenolic composites

Lignin, extracted from sugarcane bagasse by the organosolv process, was used as a partial substitute of phenol (40 w/w) in resole phenolic matrices. Short sugarcane fibers were used as reinforcement in these polymeric matrices to obtain fiber-reinforced composites. Thermoset polymers (phenolic and lignophenolic) and related composites were obtained by compression molding and characterized by mechanical tests such as impact, differential mechanical thermoanalysis (DMTA), and hardness tests. The impact test showed an improvement in the impact strength when sugarcane bagasse was used. The inner part of the fractured samples was analyzed by scanning electron microscopy (SEM), and the results indicated adhesion between fibers and matrix, because the fibers are not set free, suggesting they suffered a break during the impact test. The modification of fiber surface (mercerization and esterification) did not lead to an improvement in impact strength. The results as a whole showed that it is feasible to replace part of phenol by lignin in phenolic matrices without loss of properties. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 83: 880–888, 2002

[1]  Sabu Thomas,et al.  Effect of surface treatments on the electrical properties of low-density polyethylene composites reinforced with short sisal fibers , 1997 .

[2]  R. Landel,et al.  Mechanical Properties of Polymers and Composites , 1993 .

[3]  E. C. Mclaughlin.  The strength of bagasse fibre-reinforced composites , 1980 .

[4]  E. Frollini,et al.  Thermal conductivity of polymers by hot‐wire method , 1996 .

[5]  R. Ramaswamy,et al.  Reactive compatibilization of a nitrile rubber/phenolic resin blend: Effect on adhesive and composite properties , 1998 .

[6]  J. M. F. Paiva,et al.  Matriz termofixa fenólica em compósitos reforçados com fibras de bagaço de cana-de-açúcar , 1999 .

[7]  B. Jang,et al.  Fracture behavior of hybrid composites containing both short and continuous fibers , 1990 .

[8]  G. A. Marson,et al.  Some aspects of acylation of cellulose under homogeneous solution conditions , 1999 .

[9]  J. Hiltz,et al.  Impact performance of phenolic composites following thermal exposure , 1998 .

[10]  E.T.N. Bisanda,et al.  The manufacture of roofing panels from sisal fibre reinforced composites , 1993 .

[11]  Guilherme Andrade Marson,et al.  An efficient, one‐pot acylation of cellulose under homogeneous reaction conditions , 2000 .

[12]  A. Błędzki,et al.  Alkali treatment of jute fibers: Relationship between structure and mechanical properties , 1999 .

[13]  R. Simonson,et al.  Kraft lignin in phenol formaldehyde resin. Part 2. Evaluation of an industrial trial , 1998 .

[14]  B. Z. Jang,et al.  The response of fibrous composites to impact loading , 1990 .

[15]  E. Jinen.  Temperature dependence of the dynamic properties of phenolic-fiber-reinforced thermoplastics , 1988 .