A New High Efficiency Phase Shifted Full Bridge Converter for Sustaining Power Module of Plasma Display Panel

A new high efficiency phase shifted full bridge (PSFB) converter for sustaining power module of plasma display panel (PDP) is proposed in this paper. The proposed converter employs the rectifier of voltage doubler type without output inductor. Since it has no output inductor, the voltage stresses of the secondary rectifier diodes can be clamped at the level of the output voltage. Therefore, no dissipative resistor-capacitor (RC) snubber for rectifier diodes is needed and a high efficiency as well as low noise output voltage can be realized. In addition, due to elimination of the large output inductor, it features a simple structure, lower cost, less mass, and lighter weight. Furthermore, the proposed converter has wide zero voltage switching (ZVS) ranges with low current stresses of the primary switches. Also the resonance between the leakage inductor of the transformer and the capacitor of the voltage doubler cell makes the current stresses of the primary switches and rectifier diodes reduced. In this paper, the operational principles, analysis of the proposed converter, and the experimental results are presented

[1]  Myung-Joong Youn,et al.  Multilevel voltage wave-shaping display driver for AC plasma display panel application , 2003 .

[2]  Sang-Kyoo Han,et al.  Current-fed energy-recovery circuit for plasma display panel , 2003 .

[3]  V. Ramanarayanan,et al.  A 250 kHz/560 W phase modulated converter , 1996, Proceedings of International Conference on Power Electronics, Drives and Energy Systems for Industrial Growth.

[4]  F.C. Lee,et al.  Design considerations for high-voltage high-power full-bridge zero-voltage-switched PWM converter , 1990, Fifth Annual Proceedings on Applied Power Electronics Conference and Exposition.

[5]  Martin F. Schlecht,et al.  A 1 kW, 500 kHz front-end converter for a distributed power supply system , 1989, Proceedings, Fourth Annual IEEE Applied Power Electronics Conference and Exposition.

[6]  Song-Yi Lin,et al.  Analysis and design for RCD clamped snubber used in output rectifier of phase-shift full-bridge ZVS converters , 1998, IEEE Trans. Ind. Electron..