Bang-Bang Control Class D Amplifiers: Total Harmonic Distortion and Supply Noise

The total harmonic distortion (THD) and the power supply noise, qualified by the power supply rejection ratio (PSRR) and by the power supply induced intermodulation distortion (PS-IMD), are recognized to be potential drawbacks of class D amplifiers. In this paper, analytical expressions for the THD, PSRR, and PS-IMD of the bang-bang control class D amplifier (bang-bang amp) are derived; the bang-bang amp is arguably the most power-efficient class D amp for low-voltage power-critical applications including hearing aids. Based on the derived expressions, the effects of important parameters on the THD, PSRR, and PS-IMD are investigated, providing good insight to the design of the bang-bang amp to meet given design specifications. The analytical analyses are verified by comparing them against HSPICE simulations and hardware measurements. The bang-bang amp is also compared against the prevalent pulsewidth modulation class D amp, and in most cases, the former is shown to possess superior parameters, including lower power dissipation and hardware advantages for low-voltage power-critical applications.

[1]  Edgar Sánchez-Sinencio,et al.  THD+Noise Estimation in Class-D Amplifiers , 2007, 2007 IEEE International Symposium on Circuits and Systems.

[2]  Bah-Hwee Gwee,et al.  An investigation into the parameters affecting total harmonic distortion in low-voltage low-power Class-D amplifiers , 2003 .

[3]  Bah-Hwee Gwee,et al.  A micropower low-distortion digital class-D amplifier based on an algorithmic pulsewidth modulator , 2005, IEEE Transactions on Circuits and Systems I: Regular Papers.

[4]  Gabor C. Temes,et al.  Oversampling delta-sigma data converters : theory, design, and simulation , 1992 .

[5]  Joseph Sylvester Chang,et al.  Bang–Bang Control Class-D Amplifiers: Power-Supply Noise , 2008, IEEE Transactions on Circuits and Systems II: Express Briefs.

[6]  Joseph Sylvester Chang,et al.  Power Supply Noise in Analog Audio Class D Amplifiers , 2009, IEEE Transactions on Circuits and Systems I: Regular Papers.

[7]  H·塔卡吉施.  Class D audio amplifier , 2001 .

[8]  Pascal Lo Ré,et al.  A delta-sigma modulator for a 1-bit digital switching amplifier , 2005, IEEE Journal of Solid-State Circuits.

[9]  Joseph Sylvester Chang,et al.  Modeling and Technique to Improve PSRR and PS-IMD in Analog PWM Class-D Amplifiers , 2008, IEEE Transactions on Circuits and Systems II: Express Briefs.

[10]  Joseph Sylvester Chang,et al.  THD of Closed-Loop Analog PWM Class-D Amplifiers , 2008, IEEE Transactions on Circuits and Systems I: Regular Papers.

[11]  Edgar Sánchez-Sinencio,et al.  Design of a Class D Audio Amplifier IC Using Sliding Mode Control and Negative Feedback , 2007, IEEE Transactions on Consumer Electronics.

[12]  J. S. Chang,et al.  Analysis and design of power efficient class D amplifier output stages , 2000 .

[13]  Wing Hong Lau,et al.  Analytical technique for calculating the output harmonics of an H-bridge inverter with dead time , 1999 .

[14]  Joseph Sylvester Chang,et al.  Power Supply Noise in Bang-Bang Control Class D Amplifier , 2007, 2007 IEEE International Symposium on Circuits and Systems.

[15]  Simon Cimin Li,et al.  New high-efficiency 2.5 V/0.45 W RWDM class-D audio amplifier for portable consumer electronics , 2005, IEEE Transactions on Circuits and Systems I: Regular Papers.