The use of microemulsion for determination of sodium and potassium in biodiesel by flame atomic absorption spectrometry.

A new method for F AAS determination of sodium and potassium in biodiesel using water-in-oil microemulsion as sample preparation is proposed. The method was investigated for biodiesel produced from different sources, as soybean, castor and sunflower oil and animal fat and was also applied for vegetable oils. The optimized condition for microemulsion formation was 57.6% (w/w) of n-pentanol, 20% (w/w) of biodiesel or vegetable oil, 14.4% (w/w) of Triton X-100 and 8% (w/w) of water (aqueous standard of KCl or NaCl in/or diluted HNO(3)). The optimized instrumental parameters were: aspiration rate of 2 mL min(-1) and the flame composition of 0.131 of C(2)H(2)/air ratio. For comparison purpose, the determination of sodium and potassium were also carried out according to European norms (EN 14108 and EN 14109, respectively). These norms are applied for determination of sodium and potassium in fatty acid methylic ester samples and consist in the sample dilution using organic solvent and determination by F AAS. The stability of microemulsified aqueous standards and samples was investigated and it was found to be stable for at least 3 days while the organic standard diluted with xylene showed a decrease around of 15% in the analytical signal in 1h. The limits of detection were 0.1 microg g(-1) and 0.06 microg g(-1) and the obtained characteristic concentrations were 25 microg L(-1) and 28 microg L(-1) for sodium and potassium, respectively. The proposed method presented two times better limits of detection and better precision (0.4-1.0%) when compared with the dilution technique (1.5-4.5%). The accuracy of the method was evaluated through recovery tests and comparison with the results obtained by dilution technique. The recoveries ranged from 95% to 115% for biodiesel and 90% to 115% for vegetable oil samples. Comparison between the results obtained for biodiesel by both methods showed no significant differences at the 95% confidence level according to a Student's t-test. This study shows that the proposed method based on microemulsion as sample preparation can be applied as an efficient alternative for sodium and potassium determination in biodiesel samples.

[1]  G. Ramis‐Ramos,et al.  Direct injection of edible oils as microemulsions in a micellar mobile phase applied to the liquid chromatographic determination of synthetic antioxidants , 1999 .

[2]  H. Al-Swaidan.  Simultaneous Multielement Analysis of Saudi Arabian Petroleum by Microemulsion Inductively Coupled Plasma Mass Spectrometry (ICP/MS) , 1994 .

[3]  J. Castillo,et al.  Semiquantitative simultaneous determination of metals in olive oil using direct emulsion nebulization , 1999 .

[4]  A. J. Curtius,et al.  Simultaneous determination of Ca, P, Mg, K and Na in biodiesel by axial view inductively coupled plasma optical emission spectrometry with internal standardization after multivariate optimization. , 2007 .

[5]  B. Du,et al.  Application of microemulsions in determination of chromium naphthenate in gasoline by flame atomic absorption spectroscopy. , 1997, Talanta: The International Journal of Pure and Applied Analytical Chemistry.

[6]  M. Edlund,et al.  Analysis of biodiesel by argon–oxygen mixed-gas inductively coupled plasma optical emission spectrometry , 2002 .

[7]  S. Tyson,et al.  Biodiesel Handling and Use Guidelines , 2001 .

[8]  Z. Benzo,et al.  Determination of copper, iron and nickel in edible oils using emulsified solutions by ICP-AES , 1999 .

[9]  A. Kondo,et al.  Biodiesel fuel production by transesterification of oils. , 2001, Journal of bioscience and bioengineering.

[10]  John Klier,et al.  Properties and Applications of Microemulsions , 2000 .

[11]  B. Welz,et al.  Sequential determination of Sb and Sn in used lubricating oil by electrothermal atomic absorption spectrometry using Ru as a permanent modifier and microemulsion sample introduction , 2000 .

[12]  A. Radomska,et al.  The use of some ingredients for microemulsion preparation containing retinol and its esters. , 2000, International journal of pharmaceutics.

[13]  S. P. Moulik,et al.  Studies on the Interfacial Composition and Thermodynamic Properties of W/O Microemulsions , 2000 .

[14]  E. Torres,et al.  Biodiesel: an overview , 2005 .

[15]  T. Hoar,et al.  Transparent Water-in-Oil Dispersions: the Oleopathic Hydro-Micelle , 1943, Nature.

[16]  R. Aucélio,et al.  Electrothermal atomic absorption spectrometric method for the determination of vanadium in diesel and asphaltene prepared as detergentless microemulsions , 2004 .

[17]  A. F. Silva,et al.  Method development for the determination of nickel in petroleum using line-source and high-resolution continuum-source graphite furnace atomic absorption spectrometry , 2004 .

[18]  Application of multivariate technique in method development for the direct determination of copper in petroleum condensate using graphite furnace atomic absorption spectrometry , 2005 .

[19]  H. Al-Swaidan.  The determination of lead, nickel and vanadium in Saudi Arabian crude oil by sequential injection analysis/inductively-coupled plasma mass spectrometry. , 1996, Talanta.

[20]  C. Mendonça,et al.  Electrokinetic capillary chromatography in a polar continuous‐phase water‐in‐oil microemulsion constituted by water, sodium dodecyl sulfate, and n‐pentanol , 2005, Electrophoresis.

[21]  S. Haram,et al.  Some aspects of the role of surfactants in the formation of nanoparticles , 1998 .