Design and performance of a low noise, 128-channel ASIC preamplifier for readout of active matrix flat-panel imaging arrays

Abstract Design architecture and performance measurements of a low noise, 128-channel application-specific-integrated-circuit (ASIC) preamplifier are reported. The ASIC was designed for readout of active matrix flat-panel imager (AMFPI) arrays. Such arrays, which presently can be made as large as 41 cm×41 cm and with pixel-to-pixel pitches down to ∼70 μm, require large numbers of low noise, high density, custom integrated readout circuits. The design of this new chip is specifically tailored for research and development of active matrix flat-panel arrays for various medical imaging applications. The design architecture includes the following features: (1) Programmable signal gain which allows acquisition of a wide range of signal sizes from various array designs so as to optimize the signal-to-noise ratio; (2) Correlated double sampling (CDS) which significantly reduces certain noise components; (3) Pipelined readout (simultaneously sampling and multiplexing signals) which reduces image acquisition time; (4) Programmable bandwidth controls which balance noise and acquisition speed; and (5) Two selectable modes of output multiplexing (64:1, 16:1) for slow or fast readout. In this paper, detailed measurements of various performance parameters are presented. These measurements include noise characteristics, the relationship between bandwidth and noise, signal response linearity, channel-to-channel and pipeline cross-talk, signal gain and gain variation across channels, and the effect of sampling methods on noise. These characterizations indicate that the performance of the ASIC has achieved the original design goals.

[1]  L. Antonuk,et al.  A quantitative investigation of additive noise reduction for active matrix flat-panel imagers using compensation lines. , 2000, Medical physics.

[2]  R. J. Kansy,et al.  Response of a correlated double sampling circuit to 1/f noise , 1980 .

[3]  Marvin H. White,et al.  Characterization of surface channel CCD image arrays at low light levels , 1974 .

[4]  J Yorkston,et al.  Empirical investigation of the signal performance of a high-resolution, indirect detection, active matrix flat-panel imager (AMFPI) for fluoroscopic and radiographic operation. , 1997, Medical physics.

[5]  Y. Netzer,et al.  The design of low-noise amplifiers , 1981, Proceedings of the IEEE.

[6]  Madhu S. Gupta.  Selected Papers on Noise in Circuits and Systems , 1988 .

[7]  Larry E. Antonuk,et al.  An asynchronous, pipelined, electronic acquisition system for Active Matrix Flat-Panel Imagers (AMFPIs) , 1999 .

[8]  Larry E. Antonuk,et al.  Amorphous Silicon Sensor Arrays for Radiation Imaging , 1990 .

[9]  Larry E. Antonuk,et al.  A programmable, low noise, multichannel ASIC for readout of pixelated amorphous silicon arrays , 2000 .

[10]  L. Antonuk,et al.  Additive noise properties of active matrix flat-panel imagers. , 2000, Medical physics.

[11]  Richard L. Weisfield,et al.  High-resolution high fill factor a-Si:H sensor arrays for medical imaging , 1999, Medical Imaging.

[12]  Kouhei Suzuki,et al.  Development and evaluation of a large-area selenium-based flat-panel detector for real-time radiography and fluoroscopy , 1999, Medical Imaging.

[13]  J Yorkston,et al.  Initial performance evaluation of an indirect-detection, active matrix flat-panel imager (AMFPI) prototype for megavoltage imaging. , 1998, International journal of radiation oncology, biology, physics.

[14]  Kanai S. Shah,et al.  X-ray imaging using lead iodide as a semiconductor detector , 1999, Medical Imaging.

[15]  J A Rowlands,et al.  Digital radiology using active matrix readout of amorphous selenium: theoretical analysis of detective quantum efficiency. , 1997, Medical physics.

[16]  Weidong Huang,et al.  A data acquisition system for flat-panel imaging arrays , 1993 .

[17]  J H Siewerdsen,et al.  Strategies to improve the signal and noise performance of active matrix, flat-panel imagers for diagnostic x-ray applications. , 2000, Medical physics.

[18]  I. Blevis,et al.  Digital radiology using active matrix readout of amorphous selenium: construction and evaluation of a prototype real-time detector. , 1997, Medical physics.

[19]  J Yorkston,et al.  Demonstration of megavoltage and diagnostic x-ray imaging with hydrogenated amorphous silicon arrays. , 1992, Medical physics.