Common tools for quantitative time-resolved pulse and step-heating thermography – part I: theoretical basis

Several advanced pre- and post-processing tools have been developed over the last two decades, to enhance the performance of time-resolved pulse thermography, in terms of defect detection and characterisation. Two of the most efficient techniques are the Thermographic Signal Reconstruction, proposed in 2001, including a recent development based on the use of the polynomial coefficient images proposed in 2014, and the early detection of emerging contrast, proposed in 1994. The stake of this work is to show how these tools, commonly used for pulse-heating, can be applied to step-heating. The work was divided in two parts: the theoretical and analytic study is reported in the present article; the matching experimental results are discussed in a second, separate article.

[1]  P. Cielo,et al.  Pulsed photothermal evaluation of layered materials , 1984 .

[2]  L. Rosenhead.  Conduction of Heat in Solids , 1947, Nature.

[3]  J.-C. Krapez,et al.  EARLY DETECTION BY STIMULATED INFRARED THERMOGRAPHY. COMPARISON WITH ULTRASONICS AND HOLO/SHEAROGRAPHY , 1994 .

[4]  Robert Osiander,et al.  Time-resolved infrared radiometry with step heating. A review , 1998 .

[5]  Daniel L. Balageas,et al.  In Search of Early Time: An Original Approach in the Thermographic Identification of Thermophysical Properties and Defects , 2013 .

[6]  L. Balageas.  Thickness or diffusivity measurements from front-face flash experiments using the TSR (thermographic signal reconstruction) approach , 2010 .

[7]  D. Balageas,et al.  Early detection of thermal contrast in pulsed stimulated infrared thermography , 1994 .

[8]  R. C. Mcmaster.  Nondestructive testing handbook , 1959 .

[9]  Bruce A. Rubadeux,et al.  Reconstruction and enhancement of active thermographic image sequences , 2003 .

[10]  J. Spicer,et al.  Measurement of coating physical properties and detection of coating disbonds by time-resolved infrared radiometry , 1989 .

[11]  Daniel L. Balageas,et al.  Images of TSR coefficients: A simple way for rapid and efficient defect detection , 2014 .

[12]  Paolo Cielo,et al.  Pulsed photothermal modeling of layered materials , 1986 .

[13]  David C. Fleming,et al.  Non-destructive Inspection of Composites Using Step Heating Thermography , 2008 .

[14]  James R. Lhota,et al.  Automated processing of thermographic derivatives for quality assurance , 2007 .

[15]  Daniel L. Balageas,et al.  Defense and illustration of time-resolved pulsed thermography for NDE , 2011, Defense + Commercial Sensing.

[16]  Atef Mazioud,et al.  Detection of non emergent defects in asphalt pavement samples by long pulse and pulse phase infrared thermography , 2011 .

[17]  Steven M. Shepard,et al.  Advances in pulsed thermography , 2001, SPIE Defense + Commercial Sensing.

[18]  Daniel L. Balageas,et al.  Improvement of the detection of defects by pulse thermography thanks to the TSR approach in the case of a smart composite repair patch , 2010 .

[19]  Daniel L. Balageas,et al.  Common tools for quantitative pulse and step-heating thermography – part II: experimental investigation , 2015 .

[20]  L. C. Aamodt,et al.  Analysis of characteristic thermal transit times for time‐resolved infrared radiometry studies of multilayered coatings , 1990 .