Optimizing the impact strength of rotationally molded parts

Rotational molding of thermoplastics has become an important process in industry. However, the optimization of this technique has been essentially based on a trial-and-error process. In this report, an L'16 experimental matrix design based on the Taguchi method was conducted to optimize the impact strength of rotationally molded parts. Oven temperature and oven time were found to be the principal factors affecting the impact property of rotationally molded thermoplastics. Density and melt flow index measurements were also employed to identify the material and structural parameters. The part density increased with increasing total energy transmitted into the molding system. The melt flow index provides an easy indication of the mechanical properties of rotationally molded parts.

[1]  Shih-Jung Liu,et al.  An experimental study of foamed polyethylene in rotational molding , 1999 .

[2]  R. Crawford,et al.  The effect of processing variables on the formation and removal of bubbles in rotationally molded products , 1996 .

[3]  James L White,et al.  The effect of colorants on the properties of rotomolded polyethylene parts , 1996 .

[4]  M. A. Rao,et al.  Principles of rotational molding , 1972 .

[5]  G. Kuczynski,et al.  Study of sintering of poly(methyl methacrylate) , 1970 .

[6]  Z. Tadmor,et al.  Principles of Polymer Processing , 1979 .

[7]  R. J. Crawford,et al.  Computer prediction of cycle times during rotational molding of plastics , 1992 .

[8]  An Experimental Study of Rotational Molding of Polypropylene/Polyethylene Copolymers , 1997 .

[9]  J. Throne.  Some factors influencing cooling rates of rotationally molded parts , 1972 .

[10]  J. Throne.  Rotational molding heat transfer—an update , 1976 .

[11]  Madhan Shridhar Phadke,et al.  Quality Engineering Using Robust Design , 1989 .

[12]  M. Narkis.  Sintering behavior of poly(methyl methacrylate) particles , 1979 .

[13]  M. Narkis,et al.  Newtonian sintering simulator of two spherical particles , 1983 .

[14]  E. Harkin-jones,et al.  Mechanical properties of rotationally molded nyrim , 1996 .

[15]  J. Throne.  Study of the compaction and sintering of two high-performance thermoplastic polyimides† , 1989 .

[16]  G. Jayaraman,et al.  Cold compaction molding and sintering of polystyrene , 1976 .

[17]  G. Gogos,et al.  Axisymmetric finite element models for rotational molding , 1999 .

[18]  S-J. Liu.  Sintering Rheology of Semi-Crystalline Polymers , 1998 .