Abstract Concentrating photovoltaic (CPV) technology is one of the fastest growing solar energy technologies achieving higher electrical conversion efficiencies. The increase in temperature of solar CPV cell significantly reduces the performance; the efficiency of a CPV system can be improved by introducing effective thermal management or cooling system. This paper presents the design and numerical analysis of a heat sink based on micro-channels for efficient cooling of a commercial high concentration photovoltaic (HCPV) cell. A combinatory model of an array of micro-channels enclosed in a wide parallel flow channel design is developed. The optimized geometry of the micro-channel heat sink was found by using commercial CFD software ANSYS 13. Based on numerical simulations, it is found that the optimum configuration of micro-channel with 0.5 mm width and aspect ratio of 8. The micro-channels provided high heat transfer over heat generations spots and parallel flow channels resulted in lower pressure drop. The temperature rise across the micro-channel is estimated as10K in CPV module of 120 x 120 mm2 and with a pressure drop of 8.5 kPa along a single channel with six such channels in each modules at a flow rate of 0.105 liter/s.
[1]
Tapas K. Mallick,et al.
Opportunities and challenges in micro- and nano-technologies for concentrating photovoltaic cooling: A review
,
2013
.
[2]
S. Kim,et al.
Effect of tip clearance on the cooling performance of a microchannel heat sink
,
2004
.
[3]
C. Dey,et al.
Cooling of photovoltaic cells under concentrated illumination: a critical review
,
2005
.
[4]
Single-wafer integrated 140 W silicon concentrator module
,
1991,
The Conference Record of the Twenty-Second IEEE Photovoltaic Specialists Conference - 1991.
[5]
Dae-Young Lee,et al.
Comparative analysis of jet impingement and microchannel cooling for high heat flux applications
,
1999
.
[6]
Sung Jin Kim,et al.
Three-dimensional numerical optimization of a manifold microchannel heat sink
,
2003
.